Behringer Heavy Metal HM300 User manual

HEAVY METAL HM300
Heavy Metal Distortion Eects Pedal
Thank you for showing your condence in us by purchasing the BEHRINGER HEAVY METAL HM300.
This high-quality eects pedal enables you to produce super thick, tube-like distortion plus endless
sustain. Thanks to its high-performance features you can achieve the typical hard rock or heavy metal
distortion sounds.
1. Controls
(1) The LEVEL control adjusts the output level.
(2) The LOW control allows you to boost/cut the low-frequency range.
(3) The MID control allows you to boost/cut the mid-frequency range.
(4) The DIST control adjusts the amount of distortion eect and the length of the resulting sustain
time. High distortion settings will cause longer sustain times.
(5) The ON/BATT LED illuminates when the eect is activated. It also serves as a battery level indicator.
(6) Use the footswitch to activate/deactivate the eect.
(7) Use this ¼" TS IN connector to plug in the instrument cable.
(8) The ¼" TS OUT connector sends the signal to your amp.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V battery
(not included), press the hinges with a ballpoint pen and remove the pedal cover. Be careful not to
scratch the unit.
◊ The HM300 has no on/o switch. As soon as you insert the plug into the in connector,
the HM300 is on. When not in use, remove the plug from the in connector. This extends
the life of the battery.
The SERIAL NUMBER is located at the underside.
(5)
(1)
(8)
(6)
(7)
(3)(2)
(4)

HEAVY METAL HM300
MUSIC Group accepts no liability for any loss which may be suffered by any person who relies either wholly or in part upon any description, photograph, or statement
contained herein. Technical specifications, appearances and other information are subject to change without notice. All trademarks are the property of their respective owners.
MIDAS, KLARK TEKNIK, TURBOSOUND, BEHRINGER, BUGERA and DDA are trademarks or registered trademarks of MUSIC Group IP Ltd. © MUSIC Group IP Ltd.
2015 All rights reserved.
2. Safety Instructions
Do not use near water, or install near heat sources. Use only authorized attachments/accessories.
Do not service product yourself. Contact our qualied servicing personnel for servicing or repairs,
especially when power supply cord or plug is damaged.
3. Warranty
Please register your new BEHRINGER equipment right after your purchase by visiting behringer.com and
read the terms and conditions of our warranty carefully.
4. Specications
In
Connector ¼" TS
Impedance 500 kΩ
Out
Connector ¼" TS
Impedance 1 kΩ
Power Supply 9 V𝌂, 100 mA regulated
BEHRINGER PSU-SB 100 - 240 V~, 50 - 60 Hz
Power connector 2 mm DC jack,
negative center
Battery 9 V type 6LR61
Power consumption 30 mA
Dimensions 54 x 70 x 123 mm
(H x W x D) (2.1 x 2.8 x 4.8")
Weight 0.33 kg (0.73 lbs)
BEHRINGER is constantly striving to maintain the highest
professional standards. As a result of these efforts,
modifications may be made from time to time to existing
products without prior notice. Specifications and appearance
may therefore differ from those listed or shown.