Belcat PS-2000 User manual

Features : Passive
Frequency Response : 20Hz ~ 20KHz
Volume : A500KΩ
Pick-up : Piezo Ceramic pick-up
Dimension : W 46mm X H 71mm
(1.8" X 2.8")
- The jack should be pluged for proper Preamp working.
(TUNER will works regardless pluging jack)
- There is no output sound, please check if tuner or mute is turned on.
- When LCD screen is dim or no display, please check battery life.
- To prevent battery loss, please unplug jack when preamp is not in use.
- Do not disassemble for repair.
Return to your dealer for service or repair.
- Do not use too much force when operating the control.
3 4
12
Functions
PS-2000 PREAMP USER’S MANUAL
Passive Tone Control
Specification Caution
1. Volume Knob
The VOLUME controls the output volume. Turned fully counter-clockwise it is
completely OFF. Turned fully clockwise it is LOUD!
2. Tone EQ TONE CONTROL
the center detent on these tone control yield a flat tone response.
“+10” boosts the tone; “-10” cuts the tone.
Battery
A 9-volt battery powers the PS-2000 preamp. Before connecting the
instrument to an amplifier or mixer please check that a fully charged 9-volt
battery is connected.
2. Tone1. Volume
2
Tone Vol.
Passive Tone
Control
+10 +10
-10
0 5
0
1

Tone Vol.
Passive Tone
Control
+10 +10
-10
0 5
0
Masking
apeT
12mm
Out put Jack
INSTALLATION MANUAL
1. Electric Drill
3. Phillips Screwdriver
4. Router and Grinder
(cutting-edge 3mm)
5. Round File
6. Masking Tape
1. Preamp
8. Fix wire with clip.
1. Contents
2. Tool 4.Drilling hole for pick-up
1) When there is no sound or sound is stopped,
- Check guitar cable, amp or Mixer
- Check if there is batter or not. When it happens noise or distortion,
please exchange battery.
- Check if the pickup and battery connector is connected correctly
or not.
- Check if out put jack is connected correctly.
2) When there is hum-noise,
- Check the pickup is connected well or not.
- Check if the connectors are connected to correct position well
or not.
3) Some causes of the balance problem
- When the bottom of saddle or the groove of saddle is not flat.
- When saddle is installed to the groove of saddle loosly.
- When the connection is not good between the bottom of saddle
and the groove of saddle.
- When Saddle is very short
- When there is grounds on the groove of saddle.
- When Saddle is declined toward front or back.
- When the top of guitar is bended.
- When the pickup is installed to only a part of the groove of saddle.
Solution
(back page)
5. Insert EQ and battery box into hole of guitar.
6. Fasten screws properly.
5. Put plugs
into jacks.
7.Installing the pick-up
Pick-up
wire
Masking
apeT
1. Cut out the hole with template
Cutting
Template
Preamp
3. Pick-Up
5. Clip
6. Screw
2. Battery
Box
Pick-up
Wire
Clip
EQ
Battery box
Cable
Out put jack
Cable
Battery Box
Masking
apeT
Cutting
Template
3.Drilling hole for Jack
2. Cut out the hole with Battery Box
2. Drill Bit
(2.3mm or 3mm)
4. Output Jack