GETTING STARTED
GETTING STARTED
Nozzle Oscillation
Press during a wash cycle to move the nozzle back and forth for a
wider cleaning experience. Change the nozzle position by pressing
“Nozzle Oscillation” and the “Front” or “Rear” (<, >) buttons.
Automatic Oscillation Feature - You can set this function to
automatically oscillate when a wash is activated. Sit down and press the
“Nozzle Oscillation” button for 3 seconds until you hear a chime. Proceed
with Rear or Front Wash. To cancel, press the button again for
3 seconds. Make sure the seat sensor is activated during this time.
Adjustable Nozzle Position
Adjust the nozzle position forward or backward to achieve maximum
cleanliness and comfort by pressing the “Front” or “Rear” (< , >) buttons.
Auto Wash
Select the “Auto” function to activate a pre-programmed
wash and dry cycle.
•Wash (30 Seconds) + Dryer (1 minute)
Energy Saving Mode
Switch energy saving features on/off. Energy saver mode automatically
maintains the water and seat temperature at 89.6°F (32°C) while the seat is
not occupied.
OTHER ENERGY SAVING TIPS
•Keep the lid closed when not in use to prevent heat from being lost.
•Keep temperature set to low.
•Unplug the power cord if you do not plan to use the unit for an
extended period of time.
Silent Mode
•Beeping can be enabled or disabled by pressing and holding the
“Stop” and “Massage/Auto Wash” buttons simultaneously for 3 seconds
until you hear beeping.
•Single short beep - Silent mode has been disabled
Double short beeps - Silent mode has been enabled
•The new setting will automatically be saved if no other
buttons are pressed.
Deodorizer
Press to turn the deodorizer on/off. When turned on, the deodorizer will
automatically activate when seated to reduce odors, and remains active
for 1 minute after standing up.
•Single short beep - Deodorizer enabled
•Double short beep - Deodorizer disabled
Nozzle Cleaning
Automatic - This product has an automatic nozzle cleaning
function that rinses the nozzle before each use.
Manual - Press and hold the “Rear Wash” button on the side
panel without occupying seat for 3 seconds. The nozzle will fully
extend without spraying. Gently clean the nozzle with a soft cloth
or toothbrush. Press the “Stop” button to retract nozzle.
