BenQ DC 4330 User manual

EN-1
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation
Note:
This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15
of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help
Use of shielded cable is required to comply with Class B limits in Subpart B of Part 15 of the FCC rules. Do
not make any changes or modifications to the equipment unless otherwise specified in the manual. If such
changes or modifications should be made, you could be required to stop operation of the equipment.

EN-2
TRADEMARK INFORMATION
Microsoft®and Windows®are U.S. registered trademarks of Microsoft Corporation.
Pentium®is a registered trademark of Intel Corporation.
Macintosh is a trademark of Apple Computer, Inc.
SDTM and MMCTM are trademarks.
Other names and products may be trademarks or registered trademarks of their respective owners.
READ THIS FIRST
Notice:
1. Product design and specifications are subject to change without notice. This includes primary product
specifications, software, software drivers, and user's manual. This User Manual is a general reference
guide for the product.
2. The product and accessories that come with your camera may be different from those described in this
manual. This is due to the fact that different retailers often specify slightly different product inclusions
and accessories to suit their market requirements, customer demographics, and geographical preferences.
Products very often vary between retailers especially with accessories such as batteries, chargers, AC
adapters, memory cards, cables, carrying cases/pouches, and language support. Occasionally a
retailer will specify a unique product color, appearance, and internal memory capacity. Contact your
dealer for precise product definition and included accessories.
3. The manufacturer assumes no liability for any errors or discrepancies in this user's manual.
4. For driver updates, refer to our website.

EN-3
WARNINGS
Do not use this camera if it is emitting smoke (or an unusual odor), if it becomes unusually hot to the touch,
produces a peculiar noise, or exhibits any other abnormal conditions. Operating the camera in any of
these circumstances may cause a fire or an electrical shock. Stop using the camera immediately, turn the
camera off, remove the batteries, and disconnect the power source if you are using an AC power
adapter. Contact your dealer or authorized service facility for repairs. Never attempt to repair this camera
by yourself, as this may be dangerous.
Do not expose the camera to moisture and make sure no water gets into the camera. Take particular care
when using the camera under extreme weather conditions, such as rain or snow, or when operating the
camera at the beach on near water. Avoid using this camera in places subject to extreme moisture. Do
not use the camera if water has entered the camera. Turn the camera off, remove the batteries, and
disconnect the power source if you are using an AC power adapter. Unplug the adapter from the AC
power outlet after you have disconnected the camera. Contact your dealer or authorized service facility.
Do not continue to use the camera as this may cause a fire or an electrical shock.
Do not touch the power plug during a thunderstorm if you are using the AC power adapter. This may
cause an electrical shock.
Do not use the camera if any foreign objects have entered the camera. Turn the camera off, remove the
batteries, and disconnect the power source if you are using an AC power adapter. Unplug the adapter
from the AC power outlet after you have disconnected the camera. Contact your dealer or authorized
service facility. Do not continue to use the camera as this may cause a fire or an electrical shock.

EN-4
Do not place the camera in an unstable location such as on a wobbly table or sloping surface where the
camera may fall or tip over and cause injury. If the camera has been dropped or damaged, turn the camera
off and remove the batteries or AC power adapter. Contact your dealer or authorized service facility. Do
not continue to use the camera as this may cause a fire or an electrical shock.
Do not insert or drop metallic or other foreign objects into the camera through access points such as the
SD memory card slot. This may cause a fire or an electrical shock.
Do not attempt to modify this camera. Do not remove the camera casing. This may cause a fire or an
electrical shock. Internal inspection and repairs should only be carried out by an authorized service
facility.
Never operate this camera in any way while driving a vehicle. This may cause a traffic accident.

EN-5
CAUTIONS
Do not place this camera in a location affected by oil fumes or steam, such as near a cooking stove or
humidifier. This may cause a fire or an electrical shock.
Do not leave this camera in a location subject to extremely high temperatures, such as in a sealed
vehicle or in direct sunlight. Exposure to high temperatures may adversely affect the camera case and
internal components and may cause a fire.
Do not cover or wrap the camera or AC power adapter with a cloth or quilt. This may cause heat to build
up and distort the camera case and cause a fire. Always use the camera and accessories in well-
ventilated locations.
Handle the camera carefully and do not expose the camera to shock or vibration. Handling the camera
roughly may cause a malfunction.
When handling and moving the camera, always unplug it from the power source (if you are using an AC
power adapter). Unplug the adapter from the AC power outlet after you have disconnected the camera.
Failure to do so may result in an electrical shock.
Do not use batteries other than those specified for use with your camera. Use of unsuitable batteries
may result in the batteries splitting, or leaking and may cause a fire, injury, or soiling of the battery
compartment.
When placing the batteries into the camera, check the polarity markings on the batteries ( - and + ) to
ensure that the batteries are inserted correctly. Incorrect battery polarity will result in camera inoperability
and may result in the batteries splitting or leaking and causing a fire, injury, or soiling of the battery
compartment.
Remove the batteries if the camera will not be used for an extended period of time. The batteries may leak and
cause a fire, injury or soiling of the battery compartment. If the batteries leak, clean and wipe the battery
compartment carefully and install new batteries. Wash your hands carefully if you touch the battery fluid.

EN-6
CONTENTS
Introduction ................................................................................................................. 8
Overview ........................................................................................................................................... 8
Package Contents .............................................................................................................................. 9
Getting to Know Your Camera .................................... ........................................... 10
Names of Parts .................................................................................................................................. 11
Mode Dial .......................................................................................................................................... 12
LCD Monitor Indicator ....................................................................................................................... 13
Getting Started .......................................................................................................... 15
Installing Batteries ............................................................................................................................ 15
Using an AC Power Adapter (optional accessory) ......................................................................... 16
Attaching the Hand Strap ................................................................................................................. 16
Inserting an SD Memory Card (optional accessory) ....................................................................... 17
Setting the Date and Time ................................................................................................................ 18
Record Mode ............................................................................................................. 19
Taking Pictures ................................................................................................................................. 19
Using the Optical Zoom .................................................................................................................... 20
Digital Zoom Photography ................................................................................................................ 21
Self-timer Photography .................................................................................................................... 22
Using the Macro Mode ..................................................................................................................... 23
Setting the Flash ............................................................................................................................... 24
Setting Image Resolution and Quality .............................................................................................. 26
Taking Pictures Manually .................................................................................................................. 28

EN-7
Playback Mode ......................................................................................................... 29
Playing Back Photographed Images (Single-Frame Playback) ................................................................. 29
Displaying Thumbnail Images ........................................................................................................... 30
Zoom Playback ................................................................................................................................. 31
Slideshow Display ........................................................................................................................... 32
Movie Mode ............................................................................................................... 33
Recording Video Clips ..................................................................................................................... 33
Viewing Video Clips ........................................................................................................................ 34
Deleting Images ........................................................................................................ 35
Formatting the SD Memory Card ............................................................................... 37
Protecting Images ..................................................................................................... 39
Setting the DPOF ...................................................................................................... 39
Menu Options ........................................................................................................... 41
Record Menu .................................................................................................................................... 41
Manual Record Menu ....................................................................................................................... 43
Movie Menu ...................................................................................................................................... 47
Playback Menu ................................................................................................................................. 48
Setup Menu ...................................................................................................................................... 50
Transferring Recorded Images/Video Clips to Your Computer................................53
Specifications ........................... ...........................................................................56

EN-8
Introduction
Overview
Your new digital camera delivers high quality, 2048 x 1536 resolution images using a 3.3 Megapixels CCD
imager. Using either the optical viewfinder or the 1.5" TFT color image LCD monitor, you can compose
images and then examine them in detail. An auto-flash sensor automatically detects the shooting (lighting)
conditions and determines whether the flash should be used. This feature helps ensure that your images
turn out right.
16MB internal (built-in) memory lets you capture and store images without the need for an additional
memory card. However, you may wish to expand the memory capacity by using an external memory card.
In addition to still images, you can record short videos using the movie function.
Images you have taken can be downloaded to your computer using the USB cable (USB driver required for
Win 98 and Mac OS 8.6) You can enhance and retouch your images on your computer by using the
provided editing software, or image editing software you may already own. You may share your images
with your friends via e-mail, in a report, or on a website.
DPOF functionality allows you to print your images on a DPOF compatible printer by simply inserting the
memory card.

EN-9
Package Contents
Carefully unpack your camera and ensure that you have the following items:
Common Product Components:
Digital camera
USB cable
A/V cable
Software CD-ROM
User's manual
Camera strap
Common (Optional) Accessories:
Memory card
Camera pouch
AC power adapter
Batteries
Note:
Accessories and components vary by retailer.

EN-10
Getting to Know Your Camera