BEROTEC CUMPAN User manual

FANTIC Caballero 125
CUMPAN
BEROTECBEROTEC
Benutzerhandbuch
User Guide
Manuel d‘utilisation
Manuale d‘uso
Manual del usuario

8
BEROTEC
CUMPAN
Installation FANTIC Caballero 125
1. Install the display unit and route the CUMPAN cable from the cockpit to the battery
2. Dismantle filter box (1) behind the cylinder
Example mounting positionExample mounting position
1
VideoVideo

9
3. Connect RPM signal cable
» Locate 2-pin connector (1) (2 white wires) behind the filter box
» Connect black cable (2) from CUMPAN with branch connector (3) to white cable (4)
3
2
4
4. Connect gear sensor plug
» Locate 2-pin connector with green-yellow cable
» Disconnect the cable from the connector
1
English

10
BEROTEC
CUMPAN
5. Locate 6-pin connector
» Disconnect blue cable from the connector
» Insert green-yellow cable from step 4 instead
6. Insert the blue cable from step 5 into the enclosed green connector (1) and connect it
to the 6-pin connector (2) on the motor side (purple cable)
2
11

11
Final allocation:
7. On the 6-pin connector, swap the white cable with the pink cable
English

12
BEROTEC
CUMPAN
8. Connect the green gear sensor plug (1) from the CUMPAN to the 6-pin plug (2) on the
engine side
9. Connect the gear sensor plug with the black-white cable
2
1

13
11.Power connection
1→Ground connection (CUMPAN and gear sensor plug)
2→12V line CUMPAN
3→12V line gear sensor plug
4→switched 12V line with fuse tap (replace fuse no. 3)
1
2
4
3
10. Insert engine temperature sensor (M6x20)
» left engine side on cylinder, upper screw on water pump
Important: Note the direction of the fuse branch (4)!Important: Note the direction of the fuse branch (4)!
English
» Settings in the „SENS“ menu: // SENSOR → UNI // COUNT → 6 // DAMPING → 120 //

[phone]
[e-mail]
www.berotec.de
BEROTEC GmbH
Georg-Schlatter-Straße 10
75031 Eppingen