BEROTEC GasGas 700 User manual

BEROTECBEROTEC
Benutzerhandbuch
User Guide
Manuel d‘utilisation
Manuale d‘uso
Manual del usuario
GasGas 700 / KTM 690 | Gepäckträger

4
BEROTEC Deutsch
Operating instructions status: 05/2021
Contact for queries: [e-mail]
SAFETY INSTRUCTIONS
Congratulations on the purchase of a product from BEROTEC.
If you have any criticism, tips, suggestions for improvement or a special request,
please do not hesitate to contact us. This document serves as a basis for the safe use and
operation of the product. In particular, the safety instructions must be observed by all users.
The luggage system is intended for use on the specified two-wheelers. Correct function
cannot be guaranteed for other applications, operation is at the user‘s own risk and to
the exclusion of any warranty. Installation and operation must be carried out in accordan-
ce with these instructions and the intended use. In case of improper use or non-obser-
vance of these instructions, no liability will be accepted for any damage that may occur.
The assembly of this product requires basic technical knowledge. In case
of doubt, the assembly should be carried out in a specialist workshop. Ob-
serve all instructions in these instructions and in the vehicle manual.
Compatibility with other accessories is not guaranteed. Moun-
ting is intended for vehicles in factory condition. Mounted accesso-
ries can change the driving characteristics and stability of the vehicle.
Basic safety instructions
Intended use

5
Deutsch English
Scope of delivery
»Luggage rack GasGas 700 / KTM 690
»Distances 35mm and 50mm (2 pieces each)
»Screws M8 * 65 (2 pieces)
»Screws M8 * 50 (2 pieces)
»M8 washers (4 pieces)
Makesurethatallpartslistedinthepartslistarepresent.Ifnecessary,haveasecondpersonhelp
you.Allpartsandconnectionsloosenedforassemblymustbereassembledinaccordancewith
the vehicle manufacturer‘s specifications or replaced with the parts supplied. All screw con-
nections must be tightened to the tightening torques specified by the vehicle manufacturer.
Finally, check whether all parts and connections have been properly mounted. Af-
ter the first 50 km, check the entire assembly and the correct tightening tor-
ques of all screw connections. Carry out visual inspections at regular intervals.
Observe the maximum permissible speed of 130 km/h. The maximum payload de-
pends on the weight distribution, the luggage securing system and the terrain traveled.
The luggage system is fitted in exchange for the original pillion handholds. The screws
supplied must be used. If the factory provided grab handles have not yet been fitted, the
mounting holes in the rear fairing must be fitted according to the manufacturer‘s speci-
fications.
Mounting

[phone]
[e-mail]
www.berotec.de
BEROTEC GmbH
Georg-Schlatter-Straße 10
75031 Eppingen
Deutschland