Safety Instructions 
 WARNING! 
Before connecting the appliance compare the 
power data (voltage and frequency) indicated on 
the characteristics plate with those of the power 
supply in question. If these data do not match 
there may be problems. In case of doubt, contact 
an electrician. 
 WARNING! 
If the electrical wire plug is removed, the 
appliance must be installed and connected by a 
technician. Contact a qualified electrician who 
knows and respects current safety standards. The 
manufacturer cannot be held responsible for 
damage resulting from fitting or connecting errors. 
 WARNING! 
The electrical safety of the appliance can only be 
guaranteed if it is earthed. The manufacturer 
cannot be held responsible for damage resulting 
from the absence of or defects in the installation’s 
protection system (e.g. electrical shock). 
 WARNING! 
Only use the appliance once it has been fitted into 
its built-in position. Only in this manner can it be 
guaranteed that users cannot access the electrical 
components. 
 WARNING! 
Never open  up  the  appliance’s  frame.  Possible 
contacts with electrical conducting parts or 
changes to electrical or mechanical components 
may  represent  a  danger  to  users’  safety  and 
prejudice the correct working of the appliance. 
 WARNING! 
Repairs and maintenance, especially of parts 
carrying electrical current, must only be done by 
technicians authorised by the manufacturer. The 
manufacturer and retailers do not accept 
responsibility for any damaged caused to people, 
animals or property as a result of repairs and 
maintenance carried out by non-authorised 
personnel. 
 WARNING! 
Repairs undertaken during the guarantee period 
must only be done by technicians authorised by 
the manufacturer. If this is not the case then any 
damage resulting from the repair in question is 
excluded from the guarantee 
 WARNING! 
The appliance must be disconnected from the 
electrical current when installation and repair work 
is being done. To disconnect the appliance from 
the current, one of the following conditions must 
apply: 
•The switchboard fuses / circuit breakers must 
be disconnected. 
•The plug should be removed from the socket. 
To remove the plug from the socket do not 
pull on the electric cable but rather pull out the 
plug itself directly.