BEST ACCESS SYSTEMS Keypad EZ User manual

Keypad EZ Quick Reference
To program a lock
1 To start programming, press 00#.
2 Enter the Administrator PIN or Supervisor
PIN,then press #. The default PIN is 9998.
3 Enter the command, then press #.For
example, to add a user, press 10#.For a list
of commands,see the back side of this card.
4 Enter code 1 associated with the command,
then press #.For example, enter the PIN you
want to add: 1234#.
5 Enter code 2 if required, then press #.For
example, enter the group for the PIN: 1#.
6 Repeat steps 3–5 to add more users, or to
complete other programming commands.
7 To end programming, press 99#.
Tips
■To cancel a command sequence,press **#.
This will let you start the command over.
■Skipping a code and pressing #will enter
the default value, if it exists. See the
Keypad EZ Programming Guide for a list of all
default values.

Progamming command reference
Commd Description Code 1 Code 2
00 Begin programming
10 Add PIN PIN Group (1–5)
11 Delete PIN PIN
12 Set privileges 0,1,2 or 3*
13 Delete group Group (1–5)
14 Enable group Group (1–5)
15 Disable group Group (1–5)
21 Set Group 1 Sprvsr PIN PIN repeat PIN
22 Set Group 2 Sprvsr PIN PIN repeat PIN
23 Set Group 3 Sprvsr PIN PIN repeat PIN
24 Set Group 4 Sprvsr PIN PIN repeat PIN
25 Set Group 5 Sprvsr PIN PIN repeat PIN
99 End programming
Commands only for the Administrator
20 Set Administrator PIN PIN repeat PIN
30†Set PIN length 3,4,5 or 6
32 Set unlock duration 1–60 (secs)
33†Reset all 33
*Enter 0 to allow no privileges, 1 for passage mode
only,2 for deadbolt override only, or 3 to allow both.
†Warning! These commands erase all programming
and set the Administrator PIN back to its default.
T80912/Rev A
www.bestaccess.com
1880935 ER7991-37 Apr 2003