BEYONICS XRT270 User manual
Revision History
Sect.
Description
By
Rev
Date
A
6/6/2022
All
Initial Release
Jack Qi
Overview/ Purpose:
To help user quickly get started with Beyonics’s XRT270 Remote Control Unit (RCU).
Package inclusions:
In this packaging: XRT270 Remote control built by Beyonics.
Not Included: 2x AAA alkaline batteries, VIZIO SmartCast TV.
Steps:
1. Insert 2x AAA alkaline batteries into RCU.
2. Check RED LED blinks. (The status LED will flash until pair successfully)
3. Test keys’ IR functionality with VIZIO TV by press keys ONE by ONE.
All keys will be response following below table.
4. Press MIC and MUTE keys to relaunch pairing mode.
Button Name Button Icon Button Description
Input
Change input on TV
Power
Toggles TV's power state between on and standby
App Shortcut 1 HBOMAX
App Shortcut 2 Netflix
App Shortcut 3 Amazon Prime Video
App Shortcut 4 Pluto
App Shortcut 5 iHeart
App Shortcut 6 CRACKLE
Mic
Microphone
WatchFree WatchFree+
Settings
TV Settings/Menu
Directional Ring (Up) Navigate TV menu Up/Channel Up (if source is Tuner or App with Channel)
Directional Ring (Down) Navigate TV menu Down/Channel Down (if source is Tuner or App with Channel)
Directional Ring (Left) Navigate TV menu Left/Rewind
Directional Ring (Right) Navigate TV menu Right/Fast Forward
OK
Confirm the selection (conditionally for Cast remotes, functions if play/pause is
pressed)
Back
Go back one menu level
Home
Launches SmartCast on TV screen
CC Closed Caption
Vol -
TV Volume Down
Vol +
TV Volume Up
Mute Mute TV Audio
Figure 1 Relaunch Pairing
5. pair RCU with VIZIO TV, follow below steps to setup.
Go to TV setting: -> Voice Remote->Unpair Remote, unpair previous RCU.
=>Pair New Remote , then TV will searching RCU.
Once pair successfully, the screen will shown next page.
6. BLE-HID key functional Test: All 22 keys are available at BT mode on VIZIO TV.
Bluetooth 2400MHz ~ 2483.5MHz Power 2.19mW PCB Antenna Gain 1.0dBi
Notes：
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer
could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirement. The device can be
used in portable exposure condition without restriction.
