Biamp SBC 2 User manual

Sound Bar - SBC 2
1:1 Drilling Template
50 mm 750 mm
Center Line
50 mm
See other side for
Installation Guide
585.0222 22SEPT2021

See other side for
Installation Guide
Sound Bar - SBC 2
Installation Guide
Mounting
Wall
Use the drilling template on the back
side of the installation guide to mark
the correct position of the brackets.
Mount the brackets onto the wall.
Then screw the four thumb screws
included in the box into the Sound Bar.
See drawing for correct placement.
Place the Sound Bar on the brackets
and adjust the two thumb screws
(marked on the drawing) for correct
spacing to the wall.
Table
Mount the four rubber feet at each
corner of the bottom of the Sound
Bar. Place the Sound Bar on any
even surface.
Thumb scews
for adjustment
Connecting
Auto On/O
Position the slide switch in the
connector panel on the back side of
the Sound Bar to "Auto On/O". Then
connect input and power cables.
RS-232
Position the slide switch in the
connector panel on the back side of
the Sound Bar to "RS-232". Then
connect input and power cables.
Scan the QR code for the product
manual and more information
about RS-232 configuration.
Connector Panel
Balanced in
USB-Audio in HDMI (ARC) in
Power
AC 100-240V
50/60Hz 60W
Standby <0.5W
Designed in Denmark
Assembled in PRC
Rx
R
R- R+ GL+ L- LTx GEQ Music
RS-232
EQ Video Conference
EQ Present
RCA in RS232 Mode
Auto
on/o
MODEL: SBC 2
biamp.com