BIC Z Series User manual
1
BIC Series Z Turntables, Owner's
Manual, Model 20Z.pdf/2
Exported from Wikisource on August 10, 2022
3
1. Play button — activates all turntable functions.
2. Program — selects manual or automatic operation,
shut-off and number of plays.
3. Tonearm finger lift — designed for positive, secure
manual handling of tonearm.
4. Cartridge shell retaining screw — locks shell firmly in
place.
5. Tonearm lock — prevents damage during transport or
accidental jarring.
6. Tonearm rest — for stylus and cartridge protection.
7. Tracking force indicator — sets desired tracking force.
8. Tonearm set-down adjustment — adjusts set-down
position of stylus at edge of record.
9. Cueing lever — initiates safe damped lowering or
raising of tonearm. . .can be used as pause control.
10. Precision gimbal bearings — for minimal horizontal
and vertical pivotal friction.
11. Bias force adjustment knob — sets corresponding Bias
force.
12. Tonearm counterweight permits dynamic zero
balancing of entire tonearm, while insuring maximum
damping.
13. Pickup height adjustment screw — user adjustable for
optimum tonearm lift.
14. Machined aluminum platter.
15. Removable manual spindle.
16. Record support — platform stabilizes records placed
on spindle for safe two-point support during multiple
play.
4
17. Speed selector — shifts drive belt to 33 1/3 rpm or 45
rpm play.
18. Suspension mounts — correlated to the mass of the
turntable assembly for maximum isolation from
external shock in all planes. (Not shown)
Dust Cover Installation
If not factory installed, thread the hinge pin into the pilot
hole located on each side, DO NOT OVER TIGHTEN. (See
Diagram)
Place the dust cover over the unit so that the cutouts in the
cover line up with the two pins. The dust cover will
properly seat and align itself with the base.
To Hinge Dust Cover
With the cover correctly positioned, grasp the front edge of
the dust cover and raise, allowing the rear to pivot on the
base. As you tilt the dust cover the back of the dust cover
will contact the base and remain in the UP position. If you
wish to lower the dust cover, simply reverse the above
procedure.
6
7
About this digital edition
This e-book comes from the online library Wikisource[1].
This multilingual digital library, built by volunteers, is
committed to developing a free accessible collection of
publications of every kind: novels, poems, magazines,
letters...
We distribute our books for free, starting from works not
copyrighted or published under a free license. You are free
to use our e-books for any purpose (including commercial
exploitation), under the terms of the Creative Commons
Attribution-ShareAlike 3.0 Unported[2] license or, at your
choice, those of the GNU FDL[3].
Wikisource is constantly looking for new members. During
the transcription and proofreading of this book, it's possible
that we made some errors. You can report them at this
page[4].
The following users contributed to this book:
PseudoSkull
1. ↑ https://en.wikisource.org
2. ↑ https://www.creativecommons.org/licenses/by-sa/3.0
3. ↑ https://www.gnu.org/copyleft/fdl.html
This manual suits for next models
1
Other BIC Turntable manuals
