Bifinett KH 2000 COLD ZONE User manual

UK
KOMPERNASS GMBH · BURGSTRASSE 21 · D-44867 BOCHUM
www.kompernass.com
ID Nr.: KH2000-04/05-V2
KH2000_Fritteuse_UK.qxd 27.11.2006 14:54 Uhr Seite 1

Cold Zone Deep Fryer KH 2000
Operating instructions
KH2000_Fritteuse_UK.qxd 27.11.2006 14:54 Uhr Seite 2

KH2000_Fritteuse_UK.qxd 27.11.2006 14:54 Uhr Seite 3














KH2000_Fritteuse_UK.qxd 27.11.2006 14:55 Uhr Seite 4

- 3 - 
KH2000
Cold Zone Deep Fryer KH 2000 Page
Safety instructions 4
Intended Use 5
Technical data 5
Description of the appliance 5
Before the First Use 5
Low-Acrylamide Cooking 5
Frying 5
Preparations 5
Frying foodstuffs 6
Solid Cooking Fats 7
After Frying 7
Changing the frying oil or fat 8
Cleaning 8
Tips 9
Home-made chips 9
Frozen Foods 9
How to hinder unwanted aftertastes: 9
Healthy Nutrition 10
Overheat Protection 10
Disposal 11
Warranty & Service 11
Table - Frying Times 11
Read the operating instructions carefully before using this appliance for the first time
and preserve this booklet for later reference. Hand over the manual to whomsoever
you might pass the appliance on to.
KH2000_Fritteuse_UK.qxd 27.11.2006 14:55 Uhr Seite 3

- 4 -

KH2000
Cold Zone Deep Fryer KH 2000
Safety instructions
Danger of electric shock!
• Connect the appliance to an electrical
wall socket with a mains voltage of
220-240 V ~ 50 Hz.
• Do not use the appliance if it has a
damaged power cable or power plug.
• Arrange for damaged or defective
power cables, power plugs and app-
liances to be repaired or exchanged as
soon as possible by Customer Services.
• Do not expose the appliance to the
rain and never use it in a humid or
wet environment.
• Ensure that the power cable never
becomes wet or moist during
operation.
• Never submerge the operating/hea-
ting element and the housing with
the power cable in water, and do
not clean these components under
running water.
 Fire hazard!
• Do not use the appliance in the vicinity
of hot surfaces.
• Some parts of the appliance become
very hot during operation. Touching
these may cause serious burns.
• Do not leave the appliance unatten-
ded when in use.
• Old or dirty fats and oils can spontan-
eously ignite themselves if overhea-
ted. Change the oils or fats in good ti-
me. In case of fire, remove the power
plug from the wall and smother the
burning fat or oil with a damp towel
or fire blanket.
NEVER use water to extinguish the
fire!
 Danger of injuries
• Keep children away from the power
cable and the appliance.Children
frequently underestimate the danger
from electrical appliances.
• Ensure that the appliance stands
securely on a firm surface.
• Do not operate the appliance if it has
sustained a fall or is damaged in any
way. Arrange for the appliance to be
checked and/or repaired by qualified
technicians.
• Hot steam is released during the
frying process, in particular open the
lid. Keep a safe distance away from
the steam.
• Ensure that all parts are completely
dry before pouring oil or liquid fat
into the deep fryer. If you do not, hot
oil or fat could splatter out.
Warning - Preventing damage to the
appliance!
• Never submerge the housing, main
cable or operating/heating element in
water, and do not clean this compo-
nent under running water.
• NEVER switch the appliance on if
there is no oil or oil level do not
reached at the min line.
• The deep fryer must be filled with oil
or fat to a level of at least between
the markings on the inner side of the
stainless steel container . First
ensure that there is sufficient oil or
fat in the deep fryer every time you
intend to switch the appliance on.
KH2000_Fritteuse_UK.qxd 27.11.2006 14:55 Uhr Seite 4

- 5 - 
• This appliance is only suitable for
deep frying food and not for boilng
liquids.
Intended Use
The deep fryer is intended for use in
private households, for frying foodstuffs.
It is not intended for use in commercial
or industrial environments.
Technical data
Rated output: 1830 - 2180 W
Mains voltage: 220-240 V ~ 50 Hz
Capacity
Oil: ca. 3 Liter
Solid fats: 2,5 kg approx.
Description of the appliance
Viewing window
Frying basket
Locking button
Handle
Detachable Operating/heating
element
Control lamp
Stepless temperature controller with
On/Off function
Lid release button
Cable compartment
Stainless steel container
Permanent metal filter
Appliance lid
Reset button
Before the First Use
Before you use the deep fryer for the
first time please clean all individual com-
ponents thoroughly and carefully dry
them (see Chapter „Cleaning“).
Low-Acrylamide Cooking
Acrylamide is a possibly carcinogenic
substance formed from a reaction with
amino acids when frying foodstuffs with
a high starch content (at temperatures
of more than 180°C).
Therefore, if possible do not fry food-
stuffs with a high starch content, for
example chips, at temperatures above
170˚C. The foodstuffs should only be
fried to golden-yellow, instead of dark
or brown. Only in this way can you
achieve a low acrylamide level.
Frying
We recommend frying oil or liquid frying
fat for use in this deep fryer. You can
also use solid cooking fats. For this, first
read the chapter „Solid Cooking Fats“.
Preparations
1. Place the appliance on a horizontal,
level and stable surface.
KH2000
KH2000_Fritteuse_UK.qxd 27.11.2006 14:55 Uhr Seite 5

- 6 -

If you wish to place the deep fryer
below the extraction fan of the
cooker, ensure that the cooker is
switched off.
2. Extending the power cable from the
cable compartment .
3. Open the appliance lid , in that you
press the lid release button together,
and open the lid upwards.
4. Pull the handle upwards until it
audibly clicks in. Remove the frying
basket .
5. Fill the dry and empty deep fryer up
to the MAX marking in the stainless
steel container with oil, liquid or
molten fat (ca. 3 l oil or ca. 2,5 kg
solid fat).
Note: NEVER fill the appliance above
the MAX marking or below the MIN
marking in the stainless steel con-
tainer .
NEVER mix different types of oil or
fat!
6. Insert the power plug into the socket.
The power cable must not make
contact with the hot areas of the
deep fryer.
Only use oils or fats which are ex-
pressly marked as non-foaming and
are suitable for deep frying. This
information is to be found on the
packaging or the labelling.
7. Place the frying basket back into
the machine.
8. Close the appliance lid .
Frying foodstuffs
1. Slide the temperature controller to
the desired temperature. The whole
of the control lamp lights up. The
oil or fat will be heated to the desired
temperature within 15 minutes. When
the set temperature has been rea-
ched, the control lamp extinguishes
except for a part on the left edge, in-
dicating the readiness of the deep
fryer.
Note: The correct frying temperatu-
re is to be found either on the food
packaging or from the table in these
operating instructions.
2. Pull the handle upwards until it
audibly clicks in.
3. Open the appliance lid , in that you
press the lid release button toget-
her, and open the lid upwards.
4. Remove the frying basket  and
place into it the food to be fried.
5. Carefully replace the frying basket
into the deep fryer.
6. Close the appliance lid . This must
audibly click in.
7. Slide the handle locking button to
the rear. The handle now allows it-
self to be lowered. The frying basket
is at the same time lowered into
the hot oil or fat.
The frying process can be overseen
through the viewing window in
the appliance lid .
KH2000
KH2000_Fritteuse_UK.qxd 27.11.2006 14:55 Uhr Seite 6

- 7 - 
Solid Cooking Fats
To avoid both a splattering of the fats
and the appliance becoming too hot,
please observe the following precautionary
measures:
• With the use of fresh fats, first melt
the blocks of fat slowly, under low heat,
in a separate pan. Carefully pour the
molten fat into the deep fryer. First
then insert the power plug into a
socket and switch the deep fryer on.
• After use, store the appliance with
the re-solidified fat at room
temperature.
Should the fat become too cold, it could
cause splattering on remelting! To help
prevent this, prick a series of holes into
the solidified fat with a wooden or pla-
stic object. Ensure that no damage is
caused to the heating element.
• To melt the fat, slide the temperature
controller to 150°C. The control
lamp lights up.
• Wait until all of the fat has melted.
First then set the desired frying
temperature.
After Frying
• When the food is ready, pull the
handle upwards until the handle
locking button clicks in.
• Leave the frying basket in this posi-
tion to drip off.
• Slide the temperature controller all
the way to the left („OFF“). The deep
fryer is now switched off. Remove the
power plug from the wall socket.
• When the food has dripped off, open
the appliance lid , in that you press
the lid release button together.
• Carefully lift the frying basket out
of the deep fryer. If necessary, shake
off any excess oil or fat over the deep
fryer.
• Tip the fried food into a bowl or a
sieve (lined with absorbent kitchen
paper!)
If you do not use the deep fryer regularly
it is recommended that, after cooling,
the oil or liquified fat is poured into a
well sealed container and stored in the
refrigerator or a cool storeroom. Fill the
container through a sieve, in order to
remove any food particles from the oil
or fat.
KH2000
KH2000_Fritteuse_UK.qxd 27.11.2006 14:55 Uhr Seite 7

- 8 -

Changing the frying oil or fat
Change the oil only when it has completely
cooled down. Solid fats must still be in a
liquid state so that they can be poured.
• Completely open the appliance lid .
• Remove the frying basket .
• Remove the operating/heating element
. Place the operating/heating element
at a clean and dry location.
• Carefully remove the stainless steel
container with the oil or fat from
the deep fryer.
• Pour the oil or fat into suitable con-
tainers, for example bottles.
Note: Used fats or oil do not belong
in the domestic refuse or on the
compost heap. Make enquiries at
your local community administration
office about suitable collection
dumps.
• Thoroughly clean all parts of the deep
fryer, as described in the Chapter
„Cleaning“.
• Refill the deep fryer with fresh oil or
fat, as described in the Chapter
„Frying“.
Cleaning
Danger!
Remove the power cable from the wall
socket before cleaning.
Allow the deep fryer to cool down.
To simplify cleaning, completely dismantle
the deep fryer:
1. Completely open the appliance lid 
and remove it by pulling upwards.
2. Pull the handle upwards, until it
audibly clicks in. Remove the frying
basket .
3. Pull the operating/heating element 
upwards from the guiding rails. Place
the operating/heating element at a
clean and dry location.
4. Take out the stainless steel container
and remove the fat or oil.
Never submerge housing, main cable or
the operating element in water, and
do not clean this component under
running water!
If required, clean this element with
a moist cloth.
• The appliance lid , the frying basket
and the stainless steel container 
can be cleaned in the dishwasher.
• Clean the housing with a moist cloth.
If required, use a mild detergent on
the cloth.
KH2000
KH2000_Fritteuse_UK.qxd 27.11.2006 14:55 Uhr Seite 8