Billion BiPAC 2073 R2 User manual

BiPAC 2073 R2
HomePlug AV 200 Ethernet Adapter
BiPAC 2074 R2
HomePlug AV 200 Ethernet Bridge
with AC Pass-Through
Quick Start Guide

Quick Start Guide

Billion BiPAC 2073 R2/2074 R2 HomePlug AV 200 Ethernet Adapter Series
-1-
FCC Certifications
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation. Any changes or modifications not expressly approved by the party
responsible for compliance could void the authority to operate equipment. This equipment has been tested and
found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to
operate the equipment.
This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used
for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not
be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be
provide with antenna installation instructions and transmitter operating conditions for satisfying RF exposure
compliance.
CE Mark Warning
This equipment complies with the requirements relating to electromagnetic compatibility, EN 55022 class B for ITE,
the essential protection requirement of Council Directive2004/108/EC and Directive2006/95/EC, Standard
EN60950-1 on the approximation of the laws of the Member States relating to electromagnetic compatibility.
Company has an on-going policy of upgrading its products and it may be possible that information in this document
is not up-to-date. Please check with your local distributors for the latest information. No part of this document can be
copied or reproduced in any form without written consent from the company.

Quick Start Guide
-2-
Package Content (BiPAC 2073 R2)
BiPAC 2073 R2 HomePlug AV 200 Ethernet Adapter
Quick Start Guide
CD (containing user manual, QSG and utility)
Ethernet (CAT-5 LAN) cable
Package Content (BiPAC 2074 R2)
BiPAC 2074 R2 HomePlug AV 200 Ethernet Bridge with AC Pass-Through
Quick Start Guide
CD (containing user manual, QSG and utility)
Ethernet (CAT-5 LAN) cable
Warning
Attention
zPlace the adapter on a stable surface.
zOnly “Homeplug AV” compliant Power Line Communication (PLC)
adapter for remote access is necessary
zDo not use the adapter in high humidity or high temperatures.
zDo not open or repair the case yourself.
zAvoid using this product and all accessories outdoors.

Billion BiPAC 2073 R2/2074 R2 HomePlug AV 200 Ethernet Adapter Series
-3-
Hardware Overview (BiPAC 2073 R2)
The LEDs and Buttons
TheRearSide TheEthernetPort
(For separated plug clip type only)
ETH:
* Lit when connected to an Ethernet device.
* Blinking when data is transmitted or received
via Ethernet port.
PLC:
* Lit when the power line sync is established.
* Blinking quickly when data is transmitted or
received.
POWER:
* Lit when the
device is
power on.
SYNC:
* Used to establish a LAN network with
other PLC adapters.
Reset:
* Press this button to for 1~3 second(s)
to reset device to factory default
settings.
Ethernet Port:
Connect the HomePlug AV device with
an Ethernet device (e.g. computer,
router, hub/switch , IP pone, IPTV
set-top-box, gaming consoles…), using
the RJ-45 Ethernet cable included.
Clip Socket:
* Install the
clip into
this
socket.
zPlease DO NOT remove or disassemble the socket clip
frequently as this may cause serious damage to your
HomePlug AV device!
Warning

Quick Start Guide
-4-
Hardware Overview (BiPAC 2074 R2)
TheLEDsandButtons TheRearSide
(EUpowersocket) (EUpowerplug)
The Ethernet Port
ETH:
* Lit when
connected to an
Ethernet device.
* Blinking when
data is transmitted
or received via
Ethernet port.
PLC:
* Lit when the
power line sync
is established.
* Blinking quickly
when data is
transmitted or
received.
POWER:
* Lit when the
device is power
on.
SYNC:
* Used to establish
a LAN network
with other PLC
adapters.
Reset:
* Press this button
to for 1~3
second(s) to reset
device to factory
default settings.
Ethernet Port:
Connect the HomePlug AV device with an
Ethernet device (e.g. computer, router,
hub/switch , IP pone, IPTV set-top-box, gaming
consoles…), using the RJ-45 Ethernet cable
included.
Power Plug
Power Plug

Billion BiPAC 2073 R2/2074 R2 HomePlug AV 200 Ethernet Adapter Series
-5-
Clip Installation (For separated plug clip type only)
Installing the clip with BiPAC 2073 R2
Follow the diagrams and direction to
install the clip.
(This is an example of EU clip.
Please check the lock instruction on
your clip. If you got the “Triangle
Lock”, refer to right diagram.)
Follow the diagrams and direction to
install the clip.
(This is an example of UK clip.
Please check the lock instruction on
your clip. If you got the “Circle
Lock”, refer to right to diagram.)

Quick Start Guide
-6-
Hardware Installation
1. Power Connection
BiPAC 2073 R2
Plug the Homeplug AV 200 Ethernet Adapter into the wall outlet/socket.
BiPAC 2074 R2
Plug the embedded AC power cable to the wall outlet/socket.
Please note that the plug type may differ according to different countries.
2. LAN Connection
Connect the supplied RJ-45 Ethernet cable to the Ethernet port on HomePlug AV 200
Ethernet bridge/adapter and the other side to the device’s Ethernet interface.
3. AC Pass-Through Connection (BiPAC 2074 R2 only)
To plug IT electrical devices (e.g.ADSL router, Set-to-box, notebook, etc..) into the built-in AC
pass-through with an embedded low-pass filter to prevent electrical noise from interfering on
your powering network.

Billion BiPAC 2073 R2/2074 R2 HomePlug AV 200 Ethernet Adapter Series
-7-
4.1 Connection of the BiPAC 2073 R2
4.2 Connection of the BiPAC 2074 R2
Setup Utility
After you complete the hardware installation, insert the CD-ROM to the CD-ROM drive to
perform Setup Utility for network configuration. The Setup Utility will auto-run. Follow the
step-by-step configuration wizard, the utility will guide you complete the basic network
configuration.
Connect a network cable
to the adapter and then
plug the BiPAC 2073 R2
into a power socket.
Then connect the BiPAC
2073 R2 to a PC,
modem, router or a
set-top-box.
Create a secure network
by simply pushing the
SYNC button for 1~3
seconds.
Connect a network cable
to the adapter and then
plug the BiPAC 2074 R2
into a power socket.
Then connect the BiPAC
2074 R2 to a PC,
modem, router or a
set-top-box.
Create a secure network
by simply pushing the
SYNC button for 1~3
seconds.

Quick Start Guide
-8-
Product Application
Product Support and Contact Information
Most problems can be solved by referring to the Troubleshooting section in the User’s Manual.If you cannot resolve the
problem with the Troubleshooting chapter, please contact the dealer where you purchased this product.
Contact Billion WORLDWIDE http://www.billion.com
Billion Product Registration
Billion is committed to before and after sales customer services. You will get the most out of your Billion's products after registration. Please
register online at http://www.biguard.com/register/ to receive valuable services and support from us.
BiPAC 2073 R2 / 2074 R2 V.101EN