Bioland G-427B User manual

REV: V1
611.427B0R-001P
Manufacturer:
BIOLAND TECHNOLOGY LTD
No.A6B7 (Block G), Shangrong Industrial .Zone,
No.5 Baolong Road, Baolong Community
Longgang District, 518116 Shenzhen,
Guangdong PEOPLE’S REPUBLIC OF CHINA
Authorized Representative:
Shanghai International Holding Corp. GmbH (Europe)
Eiffestrasse 80, 20537 Hamburg, Germany
Tel: [phone] Fax: [phone]
E-mail: [email protected]
料号：611.427B0R-001P
材质：80g书纸1C，胶装
尺寸：88x125mm

Blood Glucose Meter
G-427B
User Manual

EN
U-Kiss Blood Glucose Monitoring

Changes or modifications not expressly approved by
the party responsible for compliance could void the
user's authority to operate the equipment.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and
receiver.
-- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV
technician for help.

1 .
into liquid.
2 .
3 .
manual.
4.
r.
5 .
which are too hot to touch.
6.
7.
been damaged.
8.
all those listed below.
y,
Do not place the device in liquid, nor put it where it could fall
The following basic safety notice should always be taken.
Use the device only for the intended use described in this
Do not use adjunct which are not supplied by the produce
Do not make the device come into contact with surfaces
Do not use the device where aerosol sprays are being used.
Do not use the device if it is not working properly, or if it has
Read all the manual, and practice the test, and then use the
product to test your blood glucose. Do all quality control
checks as directed and consult with a diabetes expert.
DANGER - Misuse of this electrical device can cause
electrocution, burns, fire and other HAZARDS.
Basic safety precautions should always be taken, including
Close supervision is necessary when equipment is used b
on, or near children, handicapped persons or invalids.
KEEP THE INSTRUCTIONS IN A SAFE PLACE

DISPLAY MESSAGE…….....................................................…30
BEFORE YOU BEGIN………………………….………...…...……5
ABOUT YOUR SYSTEM……………………………………...……6
INTRODUCTION TO THE SYSTEM…….....…..........……....…..6
ABOUT ALTERNATIVE SITE TESTING (AST)………….……....7
CONTENTS OF THE KITS………………………………...………9
SETTING THE METER AND DELETING THE MEMORY........13
1. Setting the date and time………………………...........…..…..13
2. Deleting the Memory………........................................………14
THE TWO MEASURING MODES……......................................15
Comparing Meter and Laboratory Results…….........................22
CONTROL SOLUTION TEST.................……...........................23
VIEWING RESULTS ON THE METER….................................24
Recalling the Stored Test Results….........................................24
Reading the Average of Blood Glucose Results…...................25
CARE AND STORAGE FOR YOUR SYSTEM………..............26
Cleaning and Disinfection.........................................................26
METER SPECIFICATION…………………….…...………..……27
TESTING WITH BLOOD SAMPLE……………………...……….16

Installing the battery
2. If replacing the batteries, please remove the used batteries.
3. Insert 2 new (AAA) batteries with correct +/- direction.
4. Close the battery cover.
Environment Protection – Waste electrical products should not
be disposed of with household waste. Please recycle where
facilities exist. Check with your local Authority or retailer for
recycling advice.
1. Open the battery cover on the back of meter.

Please consult your healthcare professional before you do AST.
What is AST ?
Alternative site testing (AST)
means that people use parts of the
body other than the fingertips to
check their blood glucose levels.
This system allows you to test on
the palm or the forearm with the
equivalent results to fingertips
testing.

■
■
■
■
■
■
■
Lancing Device
Sterile Lancet (Optional)
Owner’s Manual
AMeter
Test Strips x50pcs
Control Solution (Optional)
● The Lancing Device can be used for several times however
the lancet should be changed after each use.
● Sterile lancet and control solution are not included in the
standard kit.
● There are three levels for the control solutions: low, normal
and high available, please contact the place of purchase for
more information.
If any items are missing from your kit or opened prior to use,
please contact local customer services or place of purchase for
assistance.

Blood Glucose Meter
1
3
2
4
5
1
2
3
4
5

The meter provides you with two modes for measuring, General
and CTL. The CTL mode should be used when a control solution
is being tested. See the table below.
CTL testing with the control solution
You can switch between each mode by:
1. Start with the meter turned off. Insert a test
strip to turn on the meter, the screen will dis-
play a flashing blood drop.
2. Press “S” to select General or CTL mode.

o reduce the chances of infection:
● Choose a clean, dry work surface.
●
● Always use a new and sterile lancet. Lancets are for single
use only.
●
● Avoid getting lotion、oils、dirt or debris in or on the lancet
and lancing device.
Note: Before testing, please read the following steps thoroughly
and carefully, please relax and do the test step by step. Simplif-
ying or changing the test procedure may produce inaccurate
results.

-17-
If your lancing device differs from the one shown here, please
refer to the manufacturer’s manual to ensure proper usage.
To reduce the chance of infection:
● Never share a lancet or the lancing device.
● Always use a new, sterile lancet. Lancets are for single use
only.
● Avoid getting hand lotion, oils, dirt, or debris when handling
the lancets.
On the lancets and the lancing device.

-18-