Bioness StimRouter Parts list manual

Neuromodulation System
1. After the EPT is charged, snap the EPT onto the StimRouter Electrode.
2. Remove the electrode liner and store it in the StimRouter Electrode Carrying Case.
3. Grasp the edges of the EPT attached to the StimRouter Electrode so the gel pads face down.
4. Adhere the end of the StimRouter Electrode, that has the EPT charging port, directly over the receiver
end of the lead. Note: The center of the gel pad should be above the receiver end of the lead.
Turning the System On/Off: Press the on/off button once and release. The button flashes green
indicating the system is on and is in standby mode. Press the on/off button once and release
to turn off the system, the button will stop flashing.
Selecting a Program: Press and hold the mode button for at least three seconds until it glows yellow.
Press the plus or minus button to change the active program (shown as A-H in
the digital display). Press the mode button again to exit program mode.
Turning Stimulation On/Off: From standby mode, press the mode button briefly until it flashes yellow
indicating that stimulation is on. Press the mode button briefly or the on/off button to turn the
stimulation off.
Change Stimulation Intensity: Press the plus or minus button in stimulation or standby
mode to change the active stimulation level (shown as 0-9 in the digital display).
User's Reference Card
StimRouter Electrode/External Pulse Transmitter (EPT) Set-Up
1 2 3 4
Patient Programmer Operating Instructions
On/Off Button
Mode Button
Plus/Minus
Buttons
Volume
Buttons
Digital Display:
Intensity Level
Program Selection
EPT Icon
Radio
Frequency
(RF) Icon
Patient
Programmer
Icon
StimRouter®, Bioness, the Bioness Logo®and LiveOn®are trademarks of Bioness Inc. | www.bioness.com
®

Troubleshooting
EPT Icon Flashes Yellow EPT Battery Charge Level is Low
EPT Icon Glows Red and “E” appears in Digital
Display EPT Malfunction
EPT Icon Flashes Red and “E” appears in
Digital Display EPT Temperature Error
EPT Icon Flashes Red and Intensity Level
Flashes in Digital Display Faulty Electrode Contact
RF Icon Flashes Red Radio Communication Failure or
EPT Battery Failure
RF Icon Glows Red and “E” appears in Digital
Display Registration Failure
Patient Programmer Icon Flashes Yellow Patient Programmer Battery
Charge Level is Low
Patient Programmer Icon Glows Red and “E”
appears in Digital Display
Patient Programmer Malfunction
or Charging Error (while charging)
1. Turn stimulation off. Grasp the tab on the StimRouter Electrode and gently pull the electrode away
from the skin. Note: Do not grasp the gel pads on the back of the electrode.
2. Attach the StimRouter electrode liner to the gel pads.
3. Store the StimRouter electrode and EPT in the StimRouter Electrode Carrying Case.
4. Remove the EPT from the StimRouter Electrode when the gel pads appear worn, can no longer
adhere to the skin, or after a maximum of four days of use.
5. Make sure the StimRouter Electrode liner is on. Hold the EPT and gently pull the StimRouter
Electrode away from the EPT to unsnap it.
StimRouter Electrode and EPT Removal
1 2 3 5
©2017
602-00632-001 Rev. C
11/2017
See User's
Guide
Rx Only
Bioness Inc.
25103 Rye Canyon Loop
Valencia, CA 91355 USA
Telephone: [phone] or 661.362.4850
Website: www.bioness.com