Audiovox AA-99BT2 Operating instructions

BUTTON 1
BUTTON 2
TRANSMITTER PROGRAMMING
GUIDE Model : AA99BT2
The transmitters included with the system have been pre-programmed
atthefactory,witheachbuttonpre-assignedtocontrolaspecificfunction
of the system. Although the system in the vehicle has a 2 channel
RECEIVER, the transmitters included with the system are capable of
transmitting3distinctcodes.Thisallowsyoutoprogrameachtransmitter
to more than one vehicle in two car family. Refer to the chart below for
access to each of the transmitter channels, and for the standard factory
button assignments.
TRANSMITTER SYSTEM RECEIVER
CHANNEL BUTTONS CHANNEL FUNCTION
1 1 1 * Remote Door Lock & Unlock
Push And Hold 3 Seconds
For Car Finder
2 2 2 Push 2 Times To Start/Stop
* Remote Emergency Panic is available only on certain models.
* Door Lock/Unlock may require additional components in certain
vehicles.
** Someofthemorecommonaccessoriesfortheseadditionalchannels
are; AS 9153 Remote window roll up
AS 9256 Remote trunk release relay

PROGRAMMING THE TRANSMITTERS
Itisimportanttorememberthatduringprogramming,each individualstep
oftheproceduremustbeexecutedwithin15secondsofthepreviousstep.
When the 15 second time limit is allowed to expire, the system will
automatically terminate the programming mode. This is indicated by a
long chirp from the siren.
Additionally,thesystemwillstorecodesfrom up to four different transmit-
ters. If a 5th transmitter is programmed to any receiver channel, then the
first transmitter programmed to that channel will be erased from the
system's memory.
To program new or additional transmitters,
1. Enter the vehicle, and turn the ignition key to the " on " position.
2. Move the program valet switch on - off - on - off - on - then off.
3. Pressandholdthelargetransmitterbuttonuntiltheparkinglightsflash,
indicating the signal has been stored into memory.
4. If you have additional transmitters ( up to a total of 4 ) that need to be
programmed, repeat step 4 for each transmitter.
5. Flipthevaletswitchonthenoff,orturntheignitionswitchofftoexitthe
program mode.
BATTERY REPLACEMENT:
ThetransmitterincorporatesasmallgreenL.E.D.builtintothe case. This
L.E.D. can be used to indicate battery condition. You will notice a
decrease in transmitter range as the battery condition deteriorates.
Transmitter battery replacement is recommended at least every 10 to 12
months, depending upon how frequently the transmitter is used. To
replace the battery...
1. Remove the transmitter cover by removing the
smallscrewfrom the back of the transmittercase.
2. Carefully unsnap the top cover of the transmitter
from the bottom cover.
3. Remove the discharged battery, making note of
theorientationofthe+and- contacts,anddispose
of properly. Install the new (type GP23A) battery,
takingcare to orient the + and - contacts properly.
4. Replace the transmitter cover, taking care not to
damage the L.E.D. or switches on the circuit
board. Reinstall the case screws.

ORDER FORM FOR 2 BUTTON TRANSMITTER
MODEL NO. AA99BT2
IMPORTANT : To help us expedite your order, please print all of the
information legibly, and mail this form and your payment according to the
instructions below.
1. Name:__________________________________________________
Address:_________________________________________________
City: __________________ State: _______ Zip Code:___________
2. Telephone Number: ( _______ ) _____________________________
3. Enter the total number of transmitters required here : _____________
4. The cost per transmitter is $ 65.00.
5. Enter the total amount enclosed here : ________________________
(New York state residents must include the appropriate sales tax.)
6. Method of payment; check one of the boxes below.
qMastercard qVisa qCheck or money order * (do not send cash)
* Make checks payable to Audiovox Corporation
7. Credit Card Number : ______________________________________
8. Credit Card Expiration Date : _____________________
Credit card purchasers can order additional or replacement
transmitters by phone. Simply dial 1 - 800 - 645 - 4994, and
follow the instructions from the operator interface.
9. Mail this form, and your check, to ;
Audiovox Electronics Corporation
150 Marcus Blvd.
Hauppauge, N.Y., 11788
Attn:TRANSMITTER DEPARTMENT
(

128-5865