Biowave GO User manual

Quick Start
Do not turn on unit until Step 7.
Plug in the AC
charger into your
BioWaveGO unit to
charge up the battery.
(Takes about 1 hour.)
1.
2.Go to biowave.com/start to learn
about connecting the device to your
body, pad placement locations, use
during treatment and charging.
3.
Find your PAD PLACEMENT PHOTO
for your specic pain condition in the
Quick Reference Guide or at:
biowave.com/start
4.
Plug blue Pad
CONNECTORS
into blue
LEADWIRE CABLE
CONNECTORS.
5. Clean your skin with
a damp washcloth in
the location the PADS
are placed. Apply Pain
Relief Pads directly
over areas of pain.
6.Plug LEADWIRE
CABLE into device
so it clicks in place.
7. Press Power Button
to turn unit on.
(AC Charger must
be disconnected
from unit.)
8. Press the PLUS
(+) button to start
treatment. Continue
to press the PLUS (+)
button throughout
treatment to keep a
strong but comfortable
sensation.
Questions?
biowave.com/start
1-877-BIOWAVE x1
(1-877-246-9283, x1)
[e-mail]

• DoNOT place Pain ReliefPads over
the heart, onthe front or sideof the
neck,or ontopof thehead.
• DoNOT place Pain ReliefPads over
open wounds,brokenskin, rashy skin or
sensitiveskinareaslikesunburnedskin.
• DoNOT use BioWaveGO ifyouhave
animplantedcardiacpacemaker.
• Pads mustNEVER touch
each other. One inch
is the minimumspacing
betweenpads. There is
NOmaximum spacing.
NOTE: BioWaveGO MAY BE USED
over any location on the body
that contains implanted metal
hardware including total joint
replacements, rods, plates,
screws, anchors or pins.
Questions?
biowave.com/start • 1-877-BIOWAVE x1 • (1-877-246-9283, x1) • [e-mail]
Contraindications
When not to use BioWaveGO
Troubleshooting
My BioWaveGO is turned on and all
it does is beep and the lights blink
ORANGE.
Answer: Please make sure the leadwire cable
is rmly plugged into the BioWaveGO unit and
into both pads and that the pads have good
adhesion to clean skin.
I cannot get the BioWaveGO and my cell
phone to pair.
Answer: Makesurethe bluetoothfunction
on yourphone is turnedon. Next connect the
BioWaveGO to yourbody then turn onthe
BioWaveGO unit. Now launch theapp and click
the pair button that appears on your iPhone.
Androidphones will pairautomatically. Once
you hear a couple of tones, yourphone has
pairedwithyour BioWaveGO.
The pads are not sticking to my skin.
Answer: It is important toclean the skinprior
toplacing the pads directly overlocations of
pain. Rubthe skin vigorously with aslightly
damp towelin the two areas the padswill be
placed. Make sure skin isdry and intactprior to
placingpads on the skin.
Rev 3 - 191009
1"