NDI®CONNECTION
The controller supports serial RS232/RS422 and IP Cross
protocol mix-control. It allows you to use RS232/RS422/IP
control on one controller to control cameras (Protocol support:
VISCA, PELCO D/P, ONVIF, VISCA over IP, CGI or NDI®) in a
single system.
Connect the keyboard’s “IP” port to a port on an Ethernet
switch to power it using PoE.
(For more information regarding adding ONVIF and VISCA
over IP cameras to be controlled by the keyboard, please see
the section on Keyboard IP Configuration.)
Use NDI®IP Control
IP Connection - Using NDI®IP Control Protocol - with IP Strea-
ming Camera.
ADDING AN NDI®CAMERA TO KEYBOARD
Adding manually from Local Area Network (LAN)
Selecting NDI®as the protocol and clicking the P/T Speed dial
will cause the NDI®Camera Setup menu to appear.
• Must know about the IP address of the camera.
• The IP address of the camera has to be within the same
subnet as the Keyboard
• Rotate the P/T Speed dial to move the cursor between the
IP address octets.
Move the cursor to each octet and use the alphanumeric
keypad to enter its value. Rotate the P/T Speed dial to move
to the next octet and repeat until all IP address octets are set
to the desired values. Click the Zoom Speed dial to save.
• Click the Zoom Speed button to save
• Exit this menu
Scanning Local Area Network (LAN) for available NDI®cameras
Cameras can be detected on the network and added to the
keyboard to be controlled
• Press the Search button to bring up the Auto Search menu
• Move the cursor to NDI-IP
• Select Yes to start the search
• A list of discovered cameras will appear showing the came-
ras that have been discovered. Scroll through the discove-
red cameras using the Zoom Speed dial
• To add a camera to be controlled by the Keyboard, press the
ADD button
• With the cursor on CAM ID, Assign the camera to a CAM ID
by rotating the Zoom Speed dial
• Click the Zoom Speed dial to save
• Move the cursor to the Title, and use the alphanumeric
keypad to give the camera a title
• Click the Zoom Speed dial to save
• Enter the username for the camera
CAMERA SETTING MENU
CAM001
TITLE: -
PROTOCOL: NDI
EXIT
NDI CAMERA SETUP MENU
IP Address:
192.168.0.13
EXIT
PoE switch
IP Network
