birzman BM17-WHTS-CAL-GAUGE User manual

Instruction Manual
Truing Stand Calibration Gauge
20 2010 100
Loosen the lead screws with a 4mm hex wrench, check that the uprights are movable.
Uprights
Reset the indication meter to 0. 20 2010 100
Place the Calibration Gauge onto the uprights, ensure all sides are in contact and parallel.
Adjust the Uprights and Callipers simultaneously until the Calibration Gauge is centered.
Tighten up the lead screws.
Lead Screws
Caution :
Acts as a replicate of a perfectly dished wheel, used to realign the uprights
and calibrate the callipers of a truing stand.
To prevent deformation and loss of accuracy, external pressure and collision
should be avoided when storing the Calibration Gauge.
(BM17-WHTS-CAL-GAUGE)

Ensure the indication meter is at 0.
Adjust the callipers with the turning dial until one arm touches the Calibration Gauge.
Loosen the two screws underneath the base with a 4mm hex wrench, then shift the base to even out the gap
between each calliper pointer and the Calibration Gauge.
Tighten up the screws and check that both arms simultaneously touch the Calibration Gauge.
Callipers
20 2010 100
20 2010 100
20 2010 100
20 2010 100
4mm hex