Bishamon ESX05 Operation manual

DO NOT use on the slope.
personnel and objects.
SEVERE PERSONAL INJURY
could result
DO NOT put hand or foot
near Scissor Mechanism or
other moving parts.
SEVERE PERSONAL INJURY or
DEATH could result
DO NOT modify table such as
extend, add conveyor etc.
which may cause unbalance
and turn over unit etc.
DO NOT slide cargo to unload
off the table. Table would
spring up suddednly and very
dangerous.
SEVERE PERSONAL INJURY and
PROPERTY DAMAGE could result
When performing Maintenance
or Inspection, remove all cargo
on table and make sure to put
Roller Stopper.
SEVERE PERSONAL INJURY
could result
KEEP FEET CLEAR of rolling
wheels
SEVERE PERSONAL INJURY or
DEATH could result
NEVER sit, stand or ride on
table.
SEVERE PERSONAL INJURY
could result
Loss of control and SEVERE
PERSONAL INJURY could result
SEVERE PERSONAL INJURY and
PROPERTY DAMAGE could result
USE ONLY in areas clear of all
In this manual, 「Warning」, 「Caution」are defined and specified as below. Notice of Warnings are
very important for safe operations. As these are very important to protect operators from accidents
resulting in personal injury and death, and damage to property, so make sure to read thoroughly and
understand fully before operation.
Warning Incorrect operation may result in serious injury or death of the operator.
Caution Incorrect operation may result in injury and damage to the property. The
occurence of the danger is lower than "Warning" articles.
Explanation of Terms and Symbols

If any abnormality is found, DO NOT use positioner until repaired and abnormality is fully
removed. Or it may result in damage to the positioner and serious injury and accidents
Make sure to lock the brake except when maneuvering. Or lifter may move all of
sudden and could result in accidents.
･DO NOT maneuver or stop positioner on the slope
･DO NOT move/manuever positioner with unstable, or excessively piled cargo
It may result in unbalance of the cargo and positioner, and could lead to collapse of
the cargo and positioner.
Never sit, stand, or ride on table. Or severe personal injury or death could result.
DO NOT put hand or foot near Scissor Mechanism or other moving parts. Or severe
personal injury or death could result.
Always observe positioner and always stay at the controls while the positioner is in
motion. STOP moving positioner immediately if load on the positioner appears to
become unstable, and restack the load.

When adjusting load setting, make sure to remove all load on the table and insert
Roller Stopper into the hole on the rail

･Do Not get under table when putting load on the table
･Make sure to use Auxiliary Handle when adjusting load setting.

DO NOT load or unload very large load at one time, and DO NOT put load on the table
vigorously. Or table could change height (jump up) suddenly and result in injury.
DO NOT put load heavier than capacity.
Distribute the load evenly on the table. DO NOT put the load on the corner or edge of
the table. Or could result in table tilting and cause accident.

3-21, 4-Chome, Hongo-Cho, Takahama City,
Aichi, Japan 444-1394
Tel. [phone], Fax. [phone]
http//www.bishamon.co.jp/