Bison PK10XL User manual

1
 Inspect all contents prior to installation. Report any missing parts to dealer immediately.
 Read all instructions before proceeding.
—— Instruction Manual ——
PK10XL
Competition Pickleball System
P A R T S L I S T
Item Qty Description Item Qty Description
A 1 Winch Post E 1 TN10CS Center Court Hold Down Strap
B 1 Non-Winch Post F 1 TNCSA Center Strap Anchor
C 1 Removable Winch Handle G 2 Lacing Cord
D 1 PK10NXL Pickleball Net H 2 PK23 or PK235 Socket (Optional)
Date: 11/7/2018 Rev: 1 B.A. N.J.C. File: \pub\pk10xl Ref#: 960921
1. Use the attached court diagram to determine where to locate and dig two
8” round and 48” deep holes 22 feet apart. See Figure 1.
2. Insert Winch (A) and Non-Winch (B) posts into the holes with the lacing
bars facing the pickleball court and fill holes with concrete. Each hole will
require between 6 and 8 1/3 cubic foot bag of concrete. Make sure to brace
posts while concrete is curing to maintain the 36 1/2” dimension and ensure
the post remain perpendicular to the court surface. See Figure 1.
3. Dig one 8" round and a minimum 12" deep hole centered between the
two pickleball posts (make sure to bell out the bottom of the hole). Insert
TNCSA Center Strap Anchor (F) with the strap retaining bar running
parallel with the PK10NXL Net (D) and fill hole with concrete. The hole
will require 2 to 3 1/3 cubic bags of concrete. See Figure 2.
4. Concrete must cure 7-10 days before continuing with PK10NXL Pickleball
Net (D) installation.
5. Stretch out PK10NXL Pickleball Net (D) across the court.
Note:
Use models PK23 or PK235 (H) for removable post installation. Use
instructions provided with these sockets for installation procedure.
48"
8"
Lacing Bar
36 1/2"
FIGURE 1
6. Hook the loop on the PK10NXL Pickleball Net (D) top cable around the
net retaining pin on Non-Winch Post (B) and over the top pulley.
See Figure 3.
7. Cut off loop and remove 12” of nylon cable coating from the top net
cable, insert cable into the winch cable hole on the Winch Post (A). Use
the Removable Winch Handle (C) to crank cable until you achieve 34” at
the center of PK10NXL Pickleball Net (D). See Figure 4.

2
FIGURE 4
8. Insert dowels through the end side tapes of PK10NXL Pickleball
Net (D).
9. Square up PK10NXL Pickleball Net (D) to each post, use Lacing
Cord (G) to secure PK10NXL Pickleball Net (D) to each post.
See Figure 3.
10. Attach TN10CS Center Court Hold Down Strap (E) to the strap
retaining bar in the TNCSA Center Strap Anchor (F). Adjust
TN10CS Center Court Hold Down Strap (E) so top of PK10NXL
Pickleball Net (D) measures 34” at the center. See Figure 2.
FIGURE 2
FIGURE 3