Bison VB01XL User manual

1
P A R T S L I S T
Item Qty Description Item Qty Description
A 1 PB130 Base B 1 Outer Pole
C
1
Inner Pole D 1 Hoop
E 1 Net F 1 Height Adjustment Pin
G 1 Hoop Angle Adjustment Pin H 1 PB130 Hardware
I 1 3/8” X 3” Hex Bolt J 1 3/8” Lock Nut
♦ Inspect all contents prior to installation. Report any missing parts to dealer immediately.
♦ Read all instructions before proceeding.
—— Instruction Manual ——
VB01XL
Acu-Set Volleyball Trainer
Date: 12/18/2014 Rev: 1 B.A. N.J.C. File: PUB\Instructions\Volleyball\VB01XL Ref#: 960704
2. Attach the Hoop (D) to the Outer Pole (B) using the 3/8”X 3” Hex Bolt (I) and the 3/8”
Lock Nut (J), be sure to feed the 3/8” X 3” Hex Bolt (I) through the end of the lanyard
that is attached to the Hoop Angle Pin (G). Adjust the Hoop (D) to the desired angle and
install the Hoop Angle Pin (G). See Figure 2.
1. Using the PB130 Hardware (H) and the Instructions included with the PB130 Base (A)
remove the PB130 Base (A) from the shipping pallet and assemble. Using the 3/8” X 3”
Hex Bolt and 3/8” Lock Nut from the PB130 Hardware (H) bolt the Inner Pole (C) into
the socket on the PB130 Base (A). See Figure 1.
Figure 1 Figure 2

2
3. Install the Net (E) on to the Hoop (D) by rolling the Velcro® straps around the Hoop (D)
and back on to themselves. See Figure 3.
4. To raise and lower the Hoop (D) remove the Height Adjustment Pin (F), raise the Outer
Pole (B), re-install the Height Adjustment Pin (F) at the desired height. See Figure 4.
D
E
Velcro
®
Figure 3 Figure 4