Bison TR95 User manual

1
————— Instruction Manual —————
MODEL TR95/96
Removable Rim Bracket
P A R T S L I S T
Item Qty Description Item Qty Description
A 1 Adapter Bracket H 4 5/16” Flat Washer
B 1Locking Pin I 2 1/4” Roll Pins
C 1 Rim Removal Bushing J 1 Top Pole
D 2 3/4” External Tooth Lock Washer K 1 Bottom Pole
E 1 3/4” Jam Nut L 1 Cotter Pin
F 4 5/16” x 2-1/2” S.F.M.S. M 1 Rim *
G 4 5/16” Hex Nut N 1 Net *
O 4 5/16” Lock WasherNote: *TR96 Only
1 each Hammer 1 each Straight Blade Screwdriver
2 each Adjustable Wrenches 1 each 1/2” Wrench
TOOLS/MATERIALS REQUIRED
♦ Inspect all contents prior to installation. Report any missing parts to dealer immediately.
♦ Read all instructions before proceeding.
Required for TR95, TR96
1. Mount Adjustable Bracket (A) to Backboard with
5/16” x 2-1/2” S.F.M.S. (F), 5/16” Flat Washers (H),
5/16” Lock Washers (O) and 5/16” Hex Nuts (G).
(Figure 1)
2. Slide rim into Adjustable Bracket (A) as far as possible.
Then insert the Locking Pin (B) into the locking
position. (Figure 1 and 2) The Locking Pin should be
above brace as shown. Insert Cotter Pin (L) on other
side of Locking Pin, or use a padlock (not provided).
G
H
B
F
A
O
SEE INSTR.#3 FOR ASSEMBLY
RIM REMOVAL BUSHING
B
L
LOCKED POSITION
STORAGE POSITION
Figure 2
Figure 1
Customer Service
[phone]
Date: 4/10/02 Rev: 6 B.A. N.J.C. File: //bisonserver/publisher/instructions/TR95&96 Ref#: 980049 & 980052

2
C
DE
D
3. Install Rim Removal Bushing on rim by
inserting the Rim Removal Bushing (C) thru
the 3/4” hole in the top of the rim. Fasten it
tightly with the 3/4” External Tooth Lock
Washer (D) and the 3/4” Jam Nut (E).
(Figure 3)
Warning!!! Rim Removal Bushing (Item C) must be
as tight as possible to prevent injury
when removing the rim.
Required for TR95, TR96
4. Assemble Removal Pole by inserting the Top
Pole (J) into the Bottom Pole (K) until both 1/4”
holes align. Insert a 1/4” Roll Pin (I) into each
hole and tap lightly with a hammer until the Roll
Pin is flush with the surface of the Bottom Pole.
(Figure 4)
K
I
J
Figure 3
Figure 4
Note: Use Caution inserting Roll Pins.
Do not bend as alignment of holes
in Removal Pole is critical!