Bissell CROSSWAVE X7 Configuration guide

CrossWave X7 Cleaning the dirty
water tank | Support
If orange dirty water tank indication light is illuminated, but the
dirty water tank is not full, follow these steps below:
•Turn machine off
•Remove dirty water tank by pressing down on button on top
of tank, grab front handle and pull tank out
•Grasp top of tank from sides and pull up to remove tank lid

•Remove strainer from tank
oDiscard debris & rinse
•Pour dirty water tank into sink and rinse

•Remove filter from the tank lid

•Hand wash filter & screen with warm water, remove debris
oAllow 24 hours for filter to fully dry before reassembling
•Rinse dirty water tank lid
•Clean float sensors on the bottom and top of dirty water tank
lid with damp cloth or napkin
oRemove all visible debris and let completely dry before
reassembling

•Clean the gold sensors on the underbody of the machine
where the top of the dirty water tank connects
•Once all parts have dried - put filter back into dirty water tank
lid, strainer back into dirty water tank, and dirty water tank lid
back onto the tank

•Insert dirty water tank back into the machine inserting the
bottom of the tank first, pivot the top toward the machine
until it clicks into place

•If orange dirty water tank is full light continues to be
illuminated after the dirty water tank and sensors have been
cleaned, please Contact Us