Bissell ICON Series Installation instructions

My ICON™ Cordless Vacuum has no power/lights
flashing | Support
•Check the outlet being used to charge machine
oTest the outlet with a different device, like a cell phone charger or small appliance
•Verify correct charger is being used
oOnly this charger should be used
•Inspect charger prongs & cord
oIf cord is damaged (not smooth) or prongs are damaged, charger should be replaced
•Connect charger to the charging port on the back of the hand vac & plug into wall outlet
•The white display lights on the battery icon should light up
oIf not, please Contact Us
•Unplug from charger & press power button
•If the lights are blinking next to the cleaning mode buttons see selections below:
oBlinking lights next to the top single dot > Contact Us
•Blinking lights next to the center 2 dots > There is an obstruction in the brush roll
> See Brush Not Turning Steps

•Blinking lights next to the bottom 3 dots & the battery icon blinks > Contact Us
•Blinking lights next to 1, 2 and 3 dots & battery icon blinks > There is an air flow blockage >
See No Suction Steps
If the machine continues to not have power, please Contact Us