Bissell PowerClean Multi Cyclonic Bagless Vacuum User manual

Quick Start
users guide
BISSELL is happy to be of service.
Contact us directly at 1-800-237-7691 or
visit the website for helpful instructions at
www.bissell.com
PLEASE DO NOT RETURN THIS PRODUCT TO THE STORE
PLEASE KEEP FOR FUTURE REFERENCE
What’s needed for assembly: Phillips head screw driver
a. Vacuum base
b. Handle (with hardware packet)
c. Hose rack
d. 14 ft Hose
e. TurboBrush®Tool
f. Combination Brush
g. Telescoping Extension Wand
Crevice Tool (inside Extension wand)
h. 2 Long Screws and
2 Short Screws
Quick tips
BISSELL Homecare, Inc.
P.O. Box 1888
Grand Rapids, MI 49501
110-4368
© 2011 BISSELL Homecare, Inc.
For additional tips and troubleshooting
Please refer to User's Guide
Earn BISSELL rewards! Register your product today!
Visit: www.bissell.com
a. d.
e.
f.
b.
g.
c.
h.
For complete users guide visit www.bissell.com
Maximizing performance
1. Empty dirt container as dirt reaches "full" line
2. Check pre-motor and Airetight®HEPA
lter monthly; clean and replace as needed
Rotating brush information
1. Brush will only activate when brush switch is
on and vacuum is reclined
2. It is recommended to turn off brush switch
when vacuuming frieze carpet
1.
1.
2.
2.
Telescoping extension Wand
1. Twist collar to "unlock" and extend wand,
lock into place
2. To retract, twist to unlock
TurboBrush Tool
1. For maximum cleaning; avoid heavy
pressure which could stop the rotating brush
1.
1.
16N5 SERIES

Assembly Ready to vacuum
1. Slide handle onto vacuum base, tighten with longer screws
2. Attach hose rack to back of vacuum. Feed power cord through center opening
3. Tighten with shorter screws
4. Identify tabbed end of hose and lock into left opening
5. Feed opposite end of hose into holder on lower right, press down rmly
to engage the white suction diverter
6. Slide crevice tool into extension wand and store in clip
7. Snap combination tool into storage clip
8. Attach TurboBrush Tool to handle
1. Adjust height for carpet or bare oor
2. Plug into electrical outlet and turn power on by pushing the power button
located on upper handle
3. Step on handle release to lower into cleaning position
4. Be sure to press rotating brush switch on located next to power button
5. Attach tool for above oor and stair cleaning
6. Empty dirt cup after each use
Your assembly is
now complete.
1. 1.
4. 4.
7. 8.
2. 2.
5. 5. 6.
3. 3.
6.
For complete users guide visit www.bissell.com