Bissell ProHeat 2X Revolution Pet Pro User manual

My ProHeat 2X® Revolution®Pet Pro Carpet Cleaner
brush is not turning | Support
Unplug the machine before continuing
•Check for obstructions in the brush area - clothing, rug, string, etc.
•Remove any obstructions
•While the machine is upright, unplug the machine and remove both tanks
•Remove the nozzle and brush chamber cover
•Press the recline pedal and lay the machine on its back
I
•Check for broken belts
oUse a flathead screwdriver and press it into the slot at the back and then front of the belt access
door
oLift to remove the belt access door

•Then, remove the wheel by the belts
•Turn the machine on its side and use a Philips screwdriver to remove the screw just underneath the
wheel
•Slide the wheel down to remove
•Lay the machine back down on its back
•Use a Phillips-head screwdriver to remove the screw on the brush roll end cap
•If the gear belt is broken, gently remove it
•If you are replacing your brush rolls, gently remove the belt
•There are washer at the ends of the brush rolls, be careful that these do not fall off or get lost
•To replace brush rolls, remove them from the metal posts and replace
•Make sure the metal post goes completely through the end of the brush roll
•The brush roll bristles should be aligned in a ‘V’ pattern

•Align brush rolls with belt at other end
•To ensure alignment, hold the end of one brush roll and twist
•The other brush roll rotates with it
•Check that washers are in place
•Reassemble the belt and end cap, securing with screws you removed
•If the flat belt is broken, gently remove the belt
•If it needs replacing for any reason, the gear belt should already be removed before removing the
flat belt
•Rotate the machine back to its side
•Feed the new flat belt through the opening so that it wraps around the red pulley
•Keep it wrapped on the red pulley and adjust the machine so it is laying on its back again
•Use your thumb to stretch the flat belt back to wrap around the metal axle
•Re-secure the wheel and belt access door
•Slide the wheel up back into the slot and secure with the screw that was removed

•Snap the belt access door back down into place
•Replace the brush cover and front nozzle to test
If brushes still won't turn contact us
•