Bissell SMARTCLEAN User manual

Movement
Key Pressed/
Control Key Action
FORWARD Vacuum will move forward until it encounters and obstacle and then it will
stop or it will move forward until another command is given.
LEFT Turn left. Pressing and holding the button makes it turn left continuously.
RIGHT Turn right. Pressing and holding the button makes it turn right continuously.
BACKWRD
Vacuum will move backward for 6 inches and then stop.
NOTE: Vacuum does NOT have cliff sensors on the back of the unit to prevent it
from falling down stairs when moving in reverse.
STOP Stop the unit.
Suction Power
Key Pressed/
Control Key Action
Adjust suction level: High
Adjust suction level: Low
Getting to Know the Remote Control
SMARTCLEAN® ROBOT
REMOTE INSTRUCTIONS
For How-To
videos, go to
www.BISSELL.com
Sections marked
with this video
icon have more
information online.
REMOTE CONTROL
FORWARD
TURN RIGHT
STOP
BACKWARDS
TURN
LEFT
AUTO
DOCKING
MAX
TIME
MODE SELECTION
SUCTION STRENGTH
SELECTION
TIME SELECTION
60
MINUTES
30
MINUTES
45
MINUTES
NOTE: Remote only
works when cleaner
is undocked and
unplugged.

21
3
Press and hold in tab on the battery tray
and pull outward with the tray to remove
Remove old battery from the tray and
replace with a new battery. (Uses one
CR2025 battery).
Replace the battery
tray in to the remote
Changing the Battery in the Remote Control
NOTE: Be sure to remove the
insulation sheet before using
your remote. It will be sticking
out of the back of the battery
door.
NOTE: For additional information, please refer to the SmartClean Robotic Vacuum User Guide.
Cleaning Mode
Key Pressed/
Control Key Action
AUTO Set the unit in auto clean mode. This mode will cycle through Spiral, Along
the Wall following, “Z” formation and Random modes.
SPIRAL Vacuum will work in circles until it encounters an obstacle. Once the unit
encounters an obstacle, it will transition to AUTO mode.
RANDOM Vacuum will move randomly around the room.
ALONG
THE WALL
Vacuum will clean along walls and edges.
Timer
Key Pressed/
Control Key Action
MAX Product continues to clean until the battery becomes low. Then returns to
its docking station.
60 Product cleans for 60 minutes then returns to its docking station.
45 Product cleans for 45 minutes then returns to its docking station.
30 Product cleans for 30 minutes then returns to its docking station.
DOCKING Sends the vacuum to begin looking for its docking station to recharge.
160-8475 rev 11/15 RevD
Troubleshooting
Remote
control
doesn’t work
Check the remote battery. Check if insulation sheet is still in the
remote. Remove by pulling the tab.
If not, replace with a new CR2025
battery per the instructions above.
The robot is off Turn the power switch on the robotic
vacuum to the ON position