BitFenix Prodigy M User manual
Prodigy M
Quick Installation Guide
Box Contents
* Contents and specificaons subject to change without noce.
•Prodigy M Case
•Prodigy M Quick Installaon Guide
oScrews:
Thumbscrews M3: x 2 (For ODD)
Standard Screw M3*5mm Round: x 25 (For 2.5" SSD & ODD& MB tray)
oAccessories:
ODD Bay Screw Brackets: x 2
Standard Screw 6-32 Hex: x 4 (For PSU)
USB 3.0 to 2.0 Apdater
HDD An-vibraon Washers x 4
Standard Screw 6*6mm Round: x 16 (For 3.5" HDD)
Motherboard Standoff grip tool: x 1 (For loosening/ghtening MB standoffs)
Motherboard Standoffs: x 9 (For MB)
Cable Ties: x 6
01
Removing side panels
a. Remove side panelsb.Remove thumbscrews
Basic Installaon
Front Top Back Side
a
b
02
a. Remove front panel by pushing
tabs from inside chassis
c. Slide drive into drive bay d. Secure with screws
(Thumbscrews M3)
b. Remove ODD bay blank and
drive bay cover from front panel
Installing 5.25" drives
03
Installing 3.5" drives
a. Remove hard disk tray
c. Secure hard disk tray
with screws
b. Install drives using 6*6mm
Round screws
a. Put drives into place b. Install drives using 6*6mm Round screws
(install heat shield if necessary)
04
b. Install drives
c. Secure with screws
(M3*5mm Round screws)
a. Remove hard disk tray by removing
screws
d. Install tray into place
Installing 2.5" drives
05
Installing 2.5" drives
a. Slide drives into place b. Secure with screws (M3*5mm Round)
06
B. Reset buon
C. Headphone jack
D. Microphone jack
E. SuperSpeed USB3.0 ports
A. Power buon
D
E
A
B
C
07
a. b.Remove top filter Install fans
c. Secure with screws
Top Fan Installaon (120mm)
d. Replace top filter
08
Boom Fan Installaon (120mm)
Boom Fan Installaon (230mm)
b. Secure with screws (Remove
heat shield if installed)
b. Secure with screws (Remove
heat shield if installed)
a. Install fans
a. Install fans
09
a. b.Install fan Secure with screws
Rear Fan Installaon
10
a. b.Remove thumbscrew Remove PSU bracket
c. d.Secure PSU with screws (
Standard
screw 6-32 hex
)
Secure with thumbscrew
PSU Installaon
11
Replacing ODD bay blank
d. Secure with screws (6-32*6mm Flat)c. Posion ODD bay screw brackets and
ODD bay blank
a. Remove front panel by pushing
tabs from inside chassis
b. Remove ODD bay blank from
front panel
12
Ver 1.0 : 2013/09
Bitfenix Co., Ltd.
3F, No.79, Sec. 1, Xintai 5th Rd.,
Xi Zhi District, New Taipei City, Taiwan, R.O.C.
For the most updated information, please visit our official website: http://www.bitfenix.com
© 2013 BITFENIX Co., Ltd. All Rights Reserved. All trademarks are registered to their respective owners.
13
Table of contents
Other BitFenix Enclosure manuals
