Panduit FRME2 User manual

For Technical Support: www.panduit.com/resources/install_maintain.asp
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2014 FS098
Page 1 of 2
Caution Label
Laser Warning Label
Grommet
Opticom Rack Mount Fiber Enclosure
Part Number: FRME2
FRME2
1 FRME Enclosure
1 FRME Kit
1 Port I.D. Label
2 Enclosure Brackets
Port I.D. Label
Saddle Clip
Grounding Lug
Bracket
DISCARD DISCARD
GROMMET CUTTING DIAGRAM
Cut the small
circle for 1"
diameter
innerduct
Cut the large
circle for 1-1/2"
diameter
innerduct
Cut the straight
lines when not
using any
innerduct
Assembly Instructions:
Determine the cable entry location on the enclosure. Remove the knockout
by inserting a screwdriver into the slot located in the center of the knockout
and apply a twisting upward motion, then lift out. Insert grommet following
proper cutting diagram. Snap in saddle clips. Grounding lug attaches to a
stud at the rear, inside the enclosure, on the top or bottom with a #10-32
nut. Apply laser warning label and caution label in a clearly visible location.
Apply port I.D. label(s) on the inside of the door.

E-mail:
[email protected]m
Phone:
866-405-6654
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2014 FS098
www.panduit.com
Page 2 of 2
Locate rack bracket on the front
mounting holes for flush mounting
Locate rack bracket on the mid
enclosure mounting holes for
projection mounting
Attach the short leg of the bracket to
the enclosure.
Bracket orientation for 23 inch rack Bracket orientation for flush mount
on a 19 inch rack
Bracket orientation for projection
mount on a 19 inch rack
Attach strain relief clip with the #10-32 screw and nut
provided.
Label Installation
Mounting Instructions