bitro LATTICE User manual

LED Carpet Matrix Lighting System for Sign Cabinets and Large Light Boxes
INSTALLATION GUIDE
Use precautions to avoid damages to the product or injuries of users. Any actions against following contents will cause serious
issues such as malfunction, electric shock, or burn.
USE DC24V ONLY
DC24V
DO NOT USE AC INPUT directly to the LEDs
AC INPUT
Do not cut or rejoin wires while product
is connected wth live power source
Maximum driver quantity per serial
connection is limited. Failure causes overload
of current and damages to the product
Refer to‘WIRE THICKNESS’table to use proper
LED module
Failure will cause dimmed output
module is limited.
Do not use the product under circumstances
listed below
- High temperature spots over 60˚C (140˚F)
- Spots draw extreme moisture or dust
Avoid performing installation under rain or
high humidity for outdoor use
Do not perform actions listed below
- Alter or modify
- Touch LED lamps with sharp objects
- Put glue or silicone over the LED lamps
PRECAUTIONS
PREPARATION
PREPARE CHANNELS
2. Make holes for wires from modules to SMPS.
3. Without bushins, wires will easily be cut and short-circuit will occur.
* Use white paint inside the box for better reection
SUPPLIES REQUIREDTOOLS REQUIRED
Lattice and power supply, UL Approved parts: Wire Nuts, Cable Ties,
IDC Connectors, VCTF(PLTC) Cable
(Optional : Silicone and Screws)
Wire Stripper, Drill, Screw Driver, Wiper
1. Clean and remove all debris from
the inside of the box
2. Drill a 1/4” hole on the corner 3. Grommet the hole for supply wire access
www.bitrogroup.com
The LATTICE

LED Carpet Matrix Lighting System for Sign Cabinets and Large Light Boxes
The LATTICE
INSTALLATION GUIDE
AC Input
DC Output
AC Input
DC Output
www.bitrogroup.com
CAUTION
When handling the module, avoid pressing
down directly on top of LED lamp and other
components
Back Front
4. Prepare Lattice and unroll it completely on the cabinet based on the orientation/instruction of the layout provided by Bitro Design Team.
5. Mount the Lattice by using either of three mounting methods as illustrated above. (note: these parts are not included)
6. Connect the power supply to the Lattice based on
the orientation/instruction of the layout provided
by Bitro Design Team. (Red: + / White: -)
7. Cap each end of wires that are not
connected to the power supply
option 1) Screw mountMount the Lattice at every 4 to 5 connecters option 2) Double sided tape option 3) Silicone
Wire Nut