BK TECHNOLOGIES BKR0608 User manual

1
7001-31153-000_Ver. 09-20 | BK Technologies
BKR0608
User Instructions
1. General
The BKR0608 is a cable assembly used for testing BKR Portable radios. This cable is compatible with
HP8920 only. If using Aeroflex 3920, please use BKR0608A.
2. The Kit
RF Coax Cable –1ea.
Double Banana
Plug Adapter -1 ea.
BNC Male Binding Post - 2 ea.
Cable Assy
Antenna Adaptor

2
7001-31153-000_Ver. 09-20 | BK Technologies
3. Set-Up
a. Please refer to the diagram below for all the setup instructions.
b. Install the BNC Binding post then the Double Banana Plug adapter to the Audio In port 1 and 2
of HP8920.
c. Connect the brown Audio output coax cable (labeled) to the Double Banana Plug Adapter.
d. Connect the other brown Mic audio coax cable to Audio Out port of HP8920.
e. Connect the DIN Connector Cable to MIC/ACC port of HP8920.
f. Connect the RF Coax cable (N-Type) to the RF IN/OUT port of HP8920.
g. Attach the Antenna Adaptor to the BKR Portable Antenna Connector.
h. Connect the RF Coax cable (SMA) to the Antenna Adaptor.
i. Connect the side connector assembly to the radio Accessory port.
DIN Conn
MIC Audio
SPKR Audio Out

3
7001-31153-000_Ver. 09-20 | BK Technologies
j. On HP8920, in RX Test mode, place the cursor to AF ANL under To Screen box then press the
cursor control knob. It should go to the next screen.
k. Place the cursor to Audio In Lo then press the cursor control knob then choose Float.
l. Go back to RX Test mode, the generator is now ready for use.
NOTE: The BKR Portable radios have a floating ground audio output and should be connected as
such.

4
7001-31153-000_Ver. 09-20 | BK Technologies
Technical Service Support - Customer Service
BK Technologies
7100 Technology Drive
Melbourne, FL 23904
[phone]
www.BKTechnologies.com