
6
ENGLISH (Original instructions)
Other batteries could burst, causing
personal injury and damage.
uNever attempt to charge non-
rechargeable batteries.
uIf the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
uDo not expose the charger to water.
uDo not open the charger.
uDo not probe the charger.
uThe appliance/battery must be
placed in a well ventilated area when
charging.
Electrical safety
Symbols on the charger
Read all of this manual carefully before using the
appliance.
#This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
$The charger is intended for indoor use only.
Labels on appliance
The following symbols appear on this appliance along with the
date code.
+Read all of this manual carefully before
using the appliance
S003AQ-15
Only use with charger S003AQ-15
Features
This tool includes some or all of the following features.
1. On/off power switch
2. Dust chamber release button
3. Dust chamber
4. Flip down brush
5. Wall bracket
6. Charger
7. Hanging attatchment
Use
Switching on and off (Fig. A)
uPush the On/off power switch (1) to the forward position to
turn on the unit.
uReturning the On/off power (1) switch will turn the unit off.
Flip down brush (Fig. B)
uFlip the brush attachment (4) into position as shown in
gure B.
Using the pull out crevice tool (Fig. C)
uExtend the crevice tool (8) as shown in gure C, until it
clicks in place.
Note: The flip down brush (4) can only be utilised when the
crevice tool is in the retracted position.
Fitting the wall bracket (Fig. D)
uFit the wall bracket (5) to a suitable wall (preferably near a
power outlet) using the screws provided.
uThe unit can then be stored, when not in use, or during the
charging procedure, utilising the hanging attachment (7).
Charging (Fig. E, F)
uPlace the charger (6) into the charging port (9) on the
handle of the unit as shown in gure E.
uPlace the charging plug into a power outlet and switch on
as shown in gure F. The charger LED will light.
Cleaning the lters (Fig. G, H, I, J, K)
uPress the dust chamber release button (2) as shown in
gure G.
uSeperate the dust chamber (3) from the motor unit as
shown in gure F.
uYou can use the easy empty feature as shown in gure I.
uLift the filter (8) out of the dust chamber (3) using the tab
(10) provided.
uEmpty the dust bowl (3) by lightly shaking over a suitable
container as shown in gure K.
uRinse out the dust-bowl with warm soapy water.
uWash the lters with warm soapy water as shown in gure
L.
uAllow the lters to dry naturally, using heat may cause the
lters to distort.
uRet the lter (8) into dust chamber (3). Make sure the
lter tabs (11) face forward. Never place the lters into
the dust chamber backwards.
uReplace the dust chamber onto the motor unit. Make sure
the release button (2) clicks into place.
Warning! Before performing any maintenance or cleaning on
the appliance, unplug the appliance.