Black & Decker FS1610R User manual

FS1610R
www.blackanddecker.ae

ENGLISH
2
Parts Identification
1 Fan head
2 Control panel
3 Fan unit
4 Support tube
5 Base
6 Base screw
7 Rear guard
8 Guard nut
9 Fan blade
10 Blade cap
11 Front guard
12 Bottom clip
13 Guard screw
14 Remote Control
13 12
11
10
9
8
72
3
4
5
6
14
1

3
ENGLISH
Intended use
Your Black & Decker fan has been designed for
circulating air. This product is intended for
household use only. Remove all the parts from
the packaging material and keep them safe.
Ensure that you have all the parts as identified
in the part identification list, if anything is
missing get in touch with your nearest Black &
Decker service agent for assistance.
Read this entire manual carefully
before using the appliance.
Safety instructions
Warning! When using mains-powered
appliances, basic safety precautions, including
the following, should always be followed to
reduce the risk of fire, electric shock, personal
injury and material damage.
•The intended use is described in this manual.
The use of any accessory or attachment or
the performance of any operation with this
appliance other than those recommended in
this instruction manual may present a risk of
personal injury.
•Retain this manual for future reference.
Using your appliance
•Make sure that the appliance is switched off
before connecting to or disconnecting from
the power supply.
•Always take care when using the appliance.
•Never pull the power supply cord to
disconnect the plug from the socket.
•Keep the power supply cord away from heat,
oil and sharp edges.
•When using an extension cord with your
appliance, make sure the extension cord is
correctly wire & rated for its use.
•Do not allow the cord set to hang over bench
tops.
•Do not use the appliance outdoors.
•Do not operate the appliance if your hands
are wet. Do not operate the appliance if you
are barefoot.
•Guide the power supply cord neatly so it does
not hang over the edge of a worktop and
cannot be caught accidentally or tripped over.
•The product must not be immersed in liquid.
•Do not operate this unit in tropical climates or
in areas where the temperature exceeds
40ºC.
•Always route the cord carefully to avoid a
tripping hazard.
Warning! Do not cover the back of the fan with
curtains or other obstructions.
Warning! Keep loose clothing, hair, jewellery etc.
away from moving parts.
Safety of others
•This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or
instruction concerning use of the appliance by
a person responsible for their safety.
•Children should be supervised to ensure that
they do not play with the appliance.
•Do not allow children or any person unfamiliar
with these instructions to use the appliance.
•Do not allow children or animals to come near
the work area or to touch the appliance or
power supply cord. Close supervision is
necessary when the appliance is used near
children.

4
ENGLISH
•Children should not be left unattended while
the fan is in use.
•It is not recommended that this product is
used by children.
•Never leave the appliance unattended when
in use.
After use
•Switch off and remove the plug from the
socket before leaving the appliance
unattended and before changing, cleaning or
inspecting any parts of the appliance.
•When not in use, the appliance should be
stored in a dry place. Children should not
have access to stored appliances.
Inspection and repairs
•Switch off the appliance before cleaning,
changing accessories or approaching parts
which move in use.
•Always allow the motor to stop turning before
removing any cover or accessory
•Before use, check the appliance for
damaged or defective parts. Check for
breakage of parts, damage to switches and
any other conditions that may affect its
operation.
•Do not use the appliance if any part is
damaged or defective.
•Have any damaged or defective parts
repaired or replaced by an authorised repair
agent.
•Before use, check the power supply cord for
signs of damage, ageing and wear.
•Do not use the appliance if the power supply
cord or mains plug is damaged or defective.
•If the power supply cord or mains plug is
damaged or defective it must be repaired by
an authorised repair agent in order to avoid a
hazard. Do not cut the power supply cord and
do not attempt to repair it yourself.
•Never attempt to remove or replace any parts
other than those specified in this manual.
•Do not attempt to repair the appliance. Take it
to your nearest Black & Decker owned or
authorised Service Centre for repair.
•Ensure that he fan is switched off and
disconnected from the mains supply before
removing the guard.
Electrical safety
Before use check that the mains voltage
corresponds to the voltage on the rating plate.
This appliance is double insulated in
accordance with EN 60335; therefore
no earth wire is required.
•To avoid the risk of electric shock, do not
immerse the cord, plug or motor unit in water
or other liquid.
•Check that the supply voltage shown on the
rating plate of the appliance matches that of
your electrical system.Any connection error
will invalidate the guarantee.
Mains plug replacement
If a new mains plug needs to be fitted:
•Safely dispose of the old plug.
•Connect the brown lead to the live terminal of
the new plug.
•Connect the blue lead to the neutral terminal.
•If the product is class l (earthed), connect the
green / yellow lead to the earth terminal.

5
ENGLISH
Warning!If your product is class ll double
insulated (only 2 wires in the cord set), no
connection is to be made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs
Any replacement fuse must be of the same
rating as the original fuse supplied with the
product.
Assembly
Make sure your fan is switched off before
connecting to or disconnecting from power
supply. Ensure that the voltage rating on the
base plate corresponds to the main voltage at
your home.
Remove all packaging from the parts of the fan.
Warning! Never use the fan without the guard in
place or if the guard is damaged.
Assembling the base and stand
•Remove the screw from the support tube by
turning it anti-clockwise.
•Place the support tube into the base.
Re-insert the screw into the support tube
from underneath. Tighten the screw by
turning it clockwise.
Fitting the fan to the stand
•Remove the screw from the bottom of the fan
unit by turning it anti-clockwise.
•Place the fan unit onto the top of the support
tube. Re-insert the screw into the fan unit.
Tighten the screw by turning it clockwise.
Fitting the fan blade and guard
•Remove the blade cap from
the motor shaft by turning it
clockwise.
•Remove the guard nut from the
motor shaft by turning it
anti-clockwise.
•Place the rear guard by positioning it on the
location pins on the fan head. (ensure that
the rear guard is in the correct orientation)
•Secure the guard on to the fan head by
re-fitting the guard nut. Tighten the guard nut
by turning it clockwise.
•Place the fan blade onto the motor shaft.

6
ENGLISH
•Secure the fan blade on to the motor shaft by
re-fitting the blade cap. Tighten the blade cap
by turning it anti-clockwise.
•Place the front guard onto the rear guard by
positioning the top clip on the uppermost part
of the rear guard. Push the top clip down and
press the rim of the front guard onto the rear
guard ensuring a tight fit all the way round.
•Close the bottom clip. Tighten the bottom clip
screw by turning it clockwise.
Use
Warning! Never use the fan without the guard in
place or if the guard is damaged.
Note:All controls can be operated from the fan
unit or from the remote control.
Switching on and off
Your Fan has four speed control to keep the
desired air flow through your room.
•To switch on, press the ON/SPEED button the
required number of times to set the desired
speed. The fan will start.
•To switch off, press the OFF button.
Symbol Speed Press Button
M Medium 1 time
H High 2 times
AUTO/L Pulse 3 times
AUTO/L Low 4 times
AUTO/L M H

7
ENGLISH
Oscillation
The fan can oscillate when in use to circulate air
around a greater area.
•Press the oscillation button to start
oscillation.
•Press the oscillation button to stop
oscillation.
Timer
The timer can be used to set the running time of
the fan.
•To switch on, press the ON/SPEED button
the required number of times to set the
desired speed. The fan will start.
•Press the timer button the required number
of times to set the run time. The fan will
automatically stop when the run time is
reached.
Adjusting the angle of the fan
The angle of the fan can be adjusted up and
down.
•Tilt the head of the fan to the desired angle.
Adjusting the height of the fan
•Loosen the screw at the top of the support
tube by turning it anti-clockwise.
•Lift the fan to the desired height.
•Tighten the screw at the top of the support
tube by turning it clockwise.
Remote control
Please insert 2 ’AAA’size batteries into the
remote as per the marking in the remote cavity.
•To fit the batteries, remove the cover from the
rear of the remote control.
•Insert 2 ‘AAA’sized batteries following the
markings in the cavity. (+ for positive and –
for negative)
•Re-fit the battery cover.
Runtime Press button
1 Hour 1 time
2 Hours 2 times
4 Hours 3 times
8 Hours 4 times
AUTO/L M H

8
ENGLISH
Note:Always point the LED on your remote
towards the fan when you are operating the fan
with the remote control.
With normal use, the batteries should last for
about six months, when the remote no longer
operates the fan, replace the batteries with new
ones.
Maintenance
Your Black & Decker fan has been designed to
operate over a long period of time with a
minimum of maintenance. Continuous
satisfactory operation depends upon proper care
and regular cleaning.
Warning! Before performing any maintenance
or cleaning of the fan, disconnect the appliance
from the power supply.
Cleaning
The main housing should be cleaned with a
clean damp cloth only.
The guard and fan blade can be removed from
the appliance and washed in warm soapy water.
Rinse with clean water and dry thoroughly with a
dry soft cloth.
Note: Do not use abrasives or chemical
cleaners on any part of this appliance.
•Do not allow the filters to get wet.
•Do not wash any part of this appliance in a
dishwasher.
•Ventilation slots should be cleaned
occasionally with a clean, dry paint brush.
Technical data
Voltage 220 – 240Volts
Supply 50Hz
Power input 60W
Weight 6.61kg

ENGLISH
9
Guarantee
Black & Decker is confident of the quality of its
products and offers an outstanding guarantee.
This guarantee statement is in addition to and in
no way prejudices your statutory rights.
The guarantee is valid within the territories of the
Member States of the European Union and the
European Free TradeArea.
If a Black & Decker product becomes defective
due to faulty materials, workmanship or lack of
conformity, within 24 months from the date of
purchase, Black & Decker guarantees to replace
defective parts, repair products subjected to fair
wear and tear or replace such products to ensure
minimum inconvenience to the customer unless:
The product has been used for trade,
professional or hire purposes;
The product has been subjected to misuse
or neglect;
The product has sustained damage
through foreign objects, substances or
accidents;
Repairs have been attempted by persons
other than authorised repair agents or
Black & Decker service staff.
To claim on the guarantee, you will need to
submit proof of purchase to the seller or an
authorised repair agent. You can check the
location of your nearest authorised repair agent
by contacting your local Black & Decker office at
the address indicated in this manual.
Alternatively, a list of authorised Black & Decker
repair agents and full details of our after-sales
service and contacts are available on the Internet
at: www.2helpU.com.
Protecting the environment
Separate collection. This product must not
be disposed of with normal household
waste.
Should you find one day that your Black &
Decker product needs replacement, or if it is of
no further use to you, do not dispose of it with
other household waste. Make this product
available for separate collection.
•Black & Decker provides a facility for
recycling Black & Decker products once they
have reached the end of their working life.
This service is provided free of charge. To
take advantage of this service please return
your product to any authorised repair agent
who will collect them on our behalf.
•You can check the location of your nearest
authorised repair agent by contacting your
local Black & Decker office at the address
indicated in this manual.Alternatively, a list of
authorized Black & Decker repair agents and
full details of our after-sales service and
contact are available on the Internet at:
www.2helpU.com.

10
ARABIC
ájɪ◊G áμÑ°T ádƒª°U 8
áMhôŸG IôØ°T 9
IôØ°ûdG AÉ£Z 10
á«eÉeC’G ájɪ◊G áμÑ°T 11
»∏Ø°ùdG ∂Ñ°ûŸG 12
ájɪ◊G áμÑ°T Qɪ°ùe 13
ácô◊G ‘ ºμëàdG ¢†Ñ≤e 14
AGõLC’G ∞jô©J
áMhôŸG ¢SCGQ 1
ºμëàdG áMƒd 2
áMhôŸG IóMh 3
ºYódG ܃ÑfCG4
áMhôŸG IóYÉb 5
IóYÉ≤dG Qɪ°ùe 6
á«Ø∏ÿG ájɪ◊G áμÑ°T 7
13 12
11
10
9
8
72
3
4
5
6
14
1