8
ENGLISH (Original instructions)
9
ENGLISH
(Original instructions)
uReplace the boiler ller cap (7), do not overtighten.
uPlug the mains plug into the power supply.
Reaching temperature (g. D)
uDepending upon the temperature of the water used to ll
the reservoir (3), the appliance will take between 6 and 11
minutes to start producing steam.
Relling the boiler reservoir
uDisconnect the appliance from the mains supply.
uWait at least 2 minutes for the water to cool and the pres-
sure to decrease before removing the boiler ller cap (7).
Warning! The ller cap may be hot during use and during the
cool down period.
uUnscrew and remove the ller cap (7).
uFill the boiler reservoir (3) with clean tap water. Do not
overll the reservoir past the MAX indicator (maximum 4
litres).
uReplace the boiler ller cap (7), do not overtighten.
uPlug the mains plug into the power supply.
Using the wallpaper stripper (g. E)
uCheck the state of your plaster before you start work
as high temperature steam can loosen weak, porous or
poorly bonded plaster. Plaster is also loosened more read-
ily in areas of cracks, holes or if the steam plate is held in
one position for too long.
uYou may be able to detect if you have weak plaster by
tapping a few areas of the walls with your knuckles. If this
produces a hollow sound, we recommend proceeding only
with extreme care.
uIn all cases test out the wallpaper stripper on a small area,
about 100 cm2 , before starting work properly.
uIf at any stage nishing plaster is loosened or you hear a
crack, do not continue. The wallpaper stripper is safe for
drywall/plaster board surfaces.
uDue to the heat generated by this product, it is possible
that certain surfaces, ie. carpets, soft furniture, table tops,
cabinets etc., could be marked or damaged. To prevent
this, ensure a wooden board or other barrier is placed
under the boiler to prevent the heat damaging the surface.
Dust sheets or newspapers are not adequate for this
purpose.
uFor best results, remove wallpaper with a scraper. Scrape
off wallpaper in a downward direction (g. F).
uAlways wear protection when removing wallpaper from the
ceiling. Be careful of condensation collecting in the steam
plate as hot water may drip (g. G and H). Empty the
steam plate regularly and never use directly above your
head.
uAlways place the steam plate in a suitable container when
left unattended, even for a few seconds, and keep the
steam plate facing away from you when in use (g. I and
J).
Storage
uAllow the appliance to cool for at least 10 minutes.
uEmpty the appliance.
uStore the appliance upright in a dry place.
Cleaning and Maintenance
Warning! Before performing any maintenance, switch off and
unplug the appliance and allow it to cool.
Occasionally rinse the boiler with tap water until it runs clear.
Do not use chemical additives.
Your BLACK+DECKER corded/cordless appliance/tool has
been designed to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Mains plug replacement (U.K. & Ireland only)
If a new mains plug needs to be tted:
uSafely dispose of the old plug.
uConnect the brown lead to the live terminal in the new
plug.
uConnect the blue lead to the neutral terminal.
uConnect the green/yellow lead to the earth terminal.
Warning! Follow the tting instructions supplied with good
quality plugs. Recommended fuse: 13 A.
Protecting the environment
ZSeparate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
Products and batteries contain materials that can be recov-
ered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
Technical data
KX3300 (Type 2)
Voltage VAC
230
Power imput W
2400
Boiler
Capacity I
4
Weight
kg 2.55
