6
ENGLISH (Original instructions)
Other batteries could burst, causing
personal injury and damage.
uNever attempt to charge non-
rechargeable batteries.
uIf the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
uDo not expose the charger to water.
uDo not open the charger.
uDo not probe the charger.
uThe appliance/battery must be
placed in a well ventilated area when
charging.
Electrical safety
Symbols on the charger
Read all of this manual carefully before using the
appliance.
#This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
$The charger is intended for indoor use only.
Labels on appliance
The following symbols appear on this appliance along with the
date code.
+Read all of this manual carefully before
using the appliance
SSC-150015
Only use with charger
SSC-150015
Features
This tool includes some or all of the following features.
1. On/off power switch
2. Main body
3. Cleaning pad
4. Charging station
5. Extendable pole (BHPC220 unit only)
6. Collar (BHPC220 unit only)
7. Handle (BHPC220 unit only)
Charging (Fig. A - B)
Securing charging station to wall
uFit the charging station (4) to a suitable wall (preferably
near a power outlet) using screws ( not provided) as
shown in figure A.
uThe unit can then be stored, when not in use, or during the
charging procedure as shown in figure B.
uWhilst charging, the charging indicator light (8) will illumi-
nate.
uWhen fully charged the charging indicator light (8) will go
off.
Fitting cleaning pad (Fig. C)
uPlace the main body of the unit (2) onto a cleaning pad,
ensuring that the ‘loop’ velcro surface located on the base
(9) engages with the ‘hook’ velcro surface located on the
cleaning pad (3), and press down firml .
Switching on and off (Fig. D)
uTo turn the speedy scrubber on, press the on/off power
switch (1).
uTo turn the speedy scrubber off, press the on/off power
switch (1) again.
Fitting the collar BHPC220 unit only (Fig. E)
uPlace the collar (6) onto the main body (2) and press down
firml , ensuring that the catch (10) clicks home securely.
uTo remove the collar press the catch (10).
Fitting the extendable pole to the collar
BHPC220 unit only (Fig. F)
uTwist the Lock on the extendable pole (5) in the direction
of the ‘unlock’ position.
uAllow the extension (5a) to emerge from the extendable
pole.
uSlot the collar (6) into the extension (5a) until the button
(6a) clicks into position.
uTwist the lock on the extendable pole (5) in the direction of
the ‘lock’ position.
Fitting handle to the extendable pole
BHPC220 unit only (Fig. F)
uSlot the handle (7) into the extendable pole (5) until the
button (7a) clicks into position.
uAdjust to desired height using the lock on the extendable
pole as above.
Hints for optimum use
The appliance can be used with a variety of cleaning
agents, including sprays, foams, rub-on gels and liquid
detergents.
