Page 7
INSTALLATION GUIDE
1. Unpack your Wine Cellar by removing all packaging materials like
carton, base, foams, adhesive tape, etc.
2. Remove all accessories, internal packaging material that was used to
hold shelves, etc., in place during transport.
3. Clean the remains of all adhesive tape used and remove all printed
material supplied.
4. Install the Wine Cellar in a convenient location away from extreme
heat and cold. Allow sufficient clearance between the Wine Cellar
and side wall so the door(s) will open without obstruction. Wine
Cellar is not designed for recessed installation.
5. The floor on which the Wine Cellar should be placed must be flat,
hard, solid, and even. The Wine Cellar should not be placed on any
soft material such as carpeting, foam, plastic, etc.
6. To level your Wine Cellar, use the two leveling legs located on the
bottom front of your Wine Cellar. Adjust by turning the legs counter
clockwise to raise or clockwise to lower your Wine Cellar. The door
will close easier if the leveling legs are extended.
7. The following is the recommended minimum clearance behind the
Wine Cellar for proper air circulation:
Sides: 2” (50mm)
Top: 2” (50mm)
Proper air circulation will help your Wine Cellar work at maximum
efficiency.
NOTE: The appliance must be correctly connected to the power supply.
SET UP & USE
WARNING
It is important to keep the power cord away from the compressor at the
back of the Wine Cellar as during operation, the compressor can reach a
high temperature and could cause serious damage to the power cord.
CAUTION
Care should be taken during handling, moving and use to avoid damaging
the refrigerant tubing or increasing the risk of a leak
