BUTTONS ALLOWED
TO STORE COPIED DATA
SRC-4015-1 is remote control with a block of five programmable buttons (marked with
blue print colour), then you may want to choose these buttons for controlling other
devices (TV set, amplifier).
TO PROGRAM THE BUTTONS
DO THE FOLLOWING:
1. Press the “On/Off TV” and “Input”
buttons at the same time and hold it for
3 seconds. When the green light will light
steadily, it means the RC is ready to learn.
2. Press the button you want to «teach» —
the green light will start blinking twice per
second. Place the infrared lamps of two RCs
opposite each other above 3 cm and press
the button on the RC of the other device,
the function of which you wish to copy
on device RC.
3. After the green light three quick blinks
and will light steadily you may continue
programming other buttons.
4. Repeat the steps 2-3 for all buttons you
want to program for controlling external
devices.
5. Press the the “On/Off TV” and “Input”
buttons to save the programmed data;
the remote will exit programming mode.
RESET
Press “Update” and “OK” buttons at
same time and hold; the LED will flash 5 times
per 2 sec. Reset is done.
CODE PAGE ALTERATION
You can switch the code page settings
of the remote if it interferes with
the independent operation of neighboring
devices (TV, stereo system, etc.).
HOW TO CHANGE
THE SRC-4015-1 CODE PAGE
Default code page value is #14.
1. Press the “APP” and “Setup” buttons
at the same time for more than 3 seconds,
the indicator blinks once and code page
value is changed to #11.
2. After second pressing - code page value
is changed to #24 and led blinks 2 times.
3. After third pressing - code page value
is returned to #14 and led blinks 3 times.
The loop switches in order 11-24-14. The green
feedback LED will blink while the code page
is changing. After the user code is switched,
if the remote control is disconnected
and the power is released, it also saves
the user code after switching.
Volume +
Volume – Turn the TVOn/Off Input Mute
SRC-4015-1
