BLAUBERG Ventilatoren AH-13 User manual

Outer ventilatiOn hOOd
INSTALLATION INSTRUCTION
EN
АН-13

www.blaubergventilatoren.de ah-13
2
OVERALL DIMENSIONS
OUTER VENTILATION HOOD MOUNTING
1. Insert the air duct from indoor to protrude from outside on
the outer wall surface.
Install the air duct with the minimum slope 3 mm downwards.
Cut the air duct excess with a hack saw or with any other
suitable tool.
If the air duct has a sound-insulating layer inside, remove it
before cutting the air duct.
Cut the sound-insulating layer to be flush with the air duct.
WARNING! If the mounting place is located at high
altitude, please refer to a mounting company possessing
an appropriate mounting equipment!
min 3 mm
10-180 mm
The outer ventilation hood is designed to prevent ingress of water and foreign objects into the ventilation equipment from outside.
PURPOSE
246 mm
194 mm
162 mm
226 mm 310 mm
300 mm
260 mm
THE UNIT SHOULD NOT BE OPERATED BY CHILDREN OR PERSONS WITH REDUCED
PHYSICAL, MENTAL, OR SENSORY CAPACITIES, OR THOSE WITHOUT
THE APPROPRIATE TRAINING.
THE UNIT MUST BE INSTALLED AND CONNECTED ONLY BY PROPERLY QUALIFIED
PERSONNEL AFTER THE APPROPRIATE BRIEFING.
THE CHOICE OF UNIT INSTALLATION LOCATION MUST PREVENT UNAUTHORIZED
ACCESS BY UNATTENDED CHILDREN.

www.blaubergventilatoren.de
ah-13
3
2. Mark the fastening holes for the outer ventilation hood and
drill 4 holes, 50 mm deep to suit the expansion anchors (6x40).
Use the back wall of the ventilation hood to facilitate the
marking.
194 mm
Ø6 mm
4 holes
246 mm
3. Insert the supplied expansion anchors 6x40 into the holes.
Undo the 5 screws to remove the front part of the hood and to
enable access to the fastening holes.
For this undo the 5 screws and remove the ventilation hood
front part.
4. Fix the back part of the ventilation hood on the wall using the
supplied screws 4x40.
5. Cover the ventilation hood with the front part.

www.blaubergventilatoren.de
B113-12EN-01