BLAUBERG Ventilatoren AH-S Series User manual

AH-S
EN INSTALLATION INSTRUCTION
OUTER VENTILATION HOOD

2
www.blaubergventilatoren.de
Outer ventilation hood AH-S
The outer ventilation hood is designed to prevent ingress of water and foreign objects into the ventilation equipment from outside.
1. Insert the air duct from indoor to protrude from outside on
the outer wall surface.
Cut the air duct excess with a hack saw or with any other
suitable tool.
If the air duct has a sound-insulating layer inside, remove it
before cutting the air duct.
Cut the sound-insulating layer to be flush with the air duct.
Warning! If the mounting place is located at high altitude
please refer to a mounting company possessing an
appropriate mounting equipment!
10-110 mm
(3⁄8"-4 5⁄16")
PURPOSE
OVERALL DIMENSIONS, MM (INCH)
OUTER VENTILATION HOOD MOUNTING
THE OUTER VENTILATION HOOD MAY NOT BE OPERATED BY CHILDREN OR PERSONS
WITH REDUCED PHYSICAL, MENTAL OR SENSORY CAPACITIES, OR LACKING THE
APPROPRIATE TRAINING.
THE CHOICE OF THE VENTILATION HOOD INSTALLATION LOCATION MUST PREVENT
UNAUTHORIZED ACCESS BY UNATTENDED CHILDREN.
ØD
C
A1
AB
H
C
Model А А1 B H C D
AH-S 100 270 mm
(10 5/8”)
280 mm
(11”)
154 mm
(6 1/16”)
205 mm
(8 1/16”) -110 mm (4 5/16”)
AH-S 125 300 mm
(11 13/16”)
310 mm
(12 3/16”)
142 mm
(5 9/16”)
260 mm
(10 1/4”) -137 mm (5 3/8”)
AH-S 160 300 mm
(11 13/16”)
310 mm
(12 3/16”)
142 mm
(5 9/16”)
260 mm
(10 1/4”) -162 mm (6 3/8”)
AH-S 150х150 300 mm
(11 13/16”)
310 mm
(12 3/16”)
142 mm
(5 9/16”)
260 mm
(10 1/4”)
155 mm
(6 1/8”) -
AH-S 164х164 300 mm
(11 13/16”)
310 mm
(12 3/16”)
142 mm
(5 9/16”)
260 mm
(10 1/4”)
175 mm
(6 7/8”) -

www.blaubergventilatoren.de
3
Outer ventilation hood AH-S
2. Mark the fastening holes for the outer ventilation hood and drill
4 holes, 50 mm deep to suit the expansion anchors. Use the back
wall of the ventilation hood to facilitate the marking.
196 mm
(7 ⁄")
Ø6 mm (¼")
4 holes
247 mm
(9 ¾")
138 mm
(5 ⁄")
Ø6 mm (¼")
4 holes
217 mm
(8 ⁄")
AH-S 125 | AH-S 160 | AH-S 150x150 | AH-S 164x164 AH-S 100
3. Insert the supplied expansion anchors 6x40 into the holes.
Disassemble the outer ventilation hood to ensure access to the
fastening holes. Remove the ventilation hood front part.
1 2
4. Fix the back wall of the ventilation hood on the wall using the
supplied screws 4x40.
5. Cover the ventilation hood with the front part.

www.blaubergventilatoren.de
AH-S_v1(1)_EN