Blichmann Tower of Power User manual

Blichmann Tower of Power Controller Factory Reset Instructions
If the Blichmann Factory Settings have been altered follow instructions below to set/verify the correct
settings. The photos below each line of instruction shows what the controller display should look like
upon completion of the step above the photo. Ensure that temperature probe is connected to ToP
controller. Blichmann Factory Reset Instructions
These instructions describe how to return or verify setting of a Tower of Power controller to Blichmann
Factory settings. It is important to read the instructions and follow all instructions in order. The
temperature sensor must be plugged in for these instructions.
Step 1. Press the ENTER and NEXT keys simultaneously to unlock the controller.
Step 2. Press ENTER again while at the Home Display in order to access the Regulation Settings Menu.
Step 3. Verify the setting. If the setting is not as the same as in image change to appropriate setting
using the UP and DOWN arrows and then press ENTER to save this value. Press the NEXT button for each
setting until you reach the final setting.

Repeat Step 3 for each subsequent setting.

Step 4. Press ENTER.
Step 5. Press and hold the ENTER key for 5 seconds until the Home Display flashes in order to access the
Initial Setting Menu.
STEP 6. Verify the setting. If the setting is not as the same as in image change to appropriate setting
using the UP and DOWN arrows and then press ENTER. Press the NEXT button for each setting until you
reach the final setting.
Repeat Step 6 for each subsequent setting.

Step 7. Press ENTER
Step 8. Press NEXT again while at the Home Display in order to access the Operation Settings Menu.
Step 9. Verify the setting. If the setting is not as the same as in image change to appropriate setting
using the UP and DOWN arrows and then press ENTER. Press the NEXT button for each setting until you
reach the final setting.

Repeat Step 9 for each subsequent setting.
Step 10. Press ENTER.

Step 11.Press NEXT three times to enter this screen.
Step 12. Change the LoC setting to LoC 2 using the UP arrow. Press ENTER and this will restore the
Blichmann Factory settings and prepare the controller for use.
The final screen should be the temperature settings