Bliss Hammocks Netted Tree Glider User manual

Made in China
Weight Capacity: 250 lbs (113.4 kgs)
Netted Tree Glider
Package Contents
Make sure all parts are present & place
them side by side for easy identification.
x1
x1
x2
PART
1
2
3
NAME QTY
Hanging
Kit
Netted
Tree Glider
Carry
Bag
Before Assembly:
Take the Tree Glider out of the box
and check the material. If the
material has any structural damage
(weakness) such as rips or tears at
the seams, stop use immediately.
Confirm that the supporting
structure is secure. Examples: Fix
the swing on two branches of a tree;
if only a single branch, then it
should be at least a 37”
circumference; swing set or another
strong fixing point or frame.
Inspect the Tree Glider, support
structure and the hanging hardware
(hanging kit) for defects including
but not limited to: unexpected bents
in the tubes; unwoven strains or
excessive twisting in the tree glider
ropes; rust or tears in the hanging
kit; rotten or rusty supporting
structure; etc.
1.
2.
3.
For Hanging Kit Instructions, please
see next page. The hanging kit is
composed of set of (2) hanging straps
with end loops; each strap has a
heavy-duty carabiner clip at one end.
ASSEMBLY INSTRUCTIONS
Step 1
Lay down all 4 sections of the Support
Tubes & Rope as illustrated above.
Step 2
Push down on the push-pins of each of
the 4 sections of the Support Tubes
into each other.
Tip: Use a flathead screwdriver if you are
uncomfortable using your fingers to press down
on the push-pin locks of the Support Tubes.
Other Safety Precautions:
If you are not familiar with construction,
hardware or the use of tools, please use a
qualified general contractor to install.
Improper installation may cause injury.
Proceed carefully and take your time getting
into and out of your Tree Glider. Tree Gliders
may tip if your weight isn’t centered. Do not
jump on a Tree Glider since it is not a
trampoline. Excessive swinging and other
rough play may result in falls and may wear
out your Tree Glider and hardware
prematurely. Small children should not play
unsupervised in your Tree Glider.
Product Warranty:
All Bliss Hammock products are
guaranteed against manufacturing defects
for 1 full year from the date of purchase.
Damage caused by the environment,
improper use, or improper care and
maintenance is not covered
*Guarantee excludes clearance/closeout
items, non-retail, private sales, and auction
website sales.
push-pin
Product Fully
Assembled

Netted Tree Glider
Step 1
Find a support structure such as the ones mentioned in the “Before
Assembly” section on the first page. Make sure the support structure is at
least 60” above the ground.
Step 2
Wrap each strap around the support structure. Distance each strap the width of
the Tree Glider Rope Loops when perpendicular to the ground (~40”). Thread
the heavy-duty carabiner clip strap end through the other end loop to secure
straps. Attach the Tree Glider Rope Loops to each heavy-duty carabiner clip.
Adjusting Height: Remove the Tree Glider Rope Loops from the heavy-duty
carabiner clips. Wrap the straps around the support structure until the Tree
Glider is at least 2 feet off the ground.
HANGING KIT INSTRUCTIONS
support structure
Height is at least 60”
above the ground.
At least 37”
circumference.
~40” Apart
Tree Glider
Rope Loops