BLUE OAK SAYLOR User manual

SAYLOR
Dining TABLE
ASSEMBLY instructions

Assemble your Blue Oak™ outdoor furniture on a soft,
non-abrasive surface such as a carpet or cardboard to avoid
damaging the item. Seek assistance to assemble bulky or
heavy items (there’s no “i” in “team”). After final alignment,
make sure all the bolts are securely tightened with hex caps
pressed in place.
If you have issues, challenges or annoyances with this product,
give us a call at 1-888-444-0367.
We’re available from 8am-5pm (EST)
Monday-Thursday and 8am-4pm (EST) on Friday.
Before You Begin:
You already know this, but
it’s best to read ALL the
instructions before
assembly. Failure to do so
may result in faulty
assembly and potential
injury (no one wants that
kind of stain on their party
hosting record).

PARTS
DESCRIPTION QTYNO.
Table Leg
A 1
Leg Connector
B 1
Table Base
C 1
Table Top
D 1
Umbrella Cap
E 1
HARDWARE
DESCRIPTION QTYNO.
M8x70 BoltAA 5
M8x20 BoltBB 4
Lock WasherCC 9
M8 WasherDD 9
Bolt Head CapEE 9
WrenchFF 1

Assembly Instructions
Take a deep breath and keep a clear spot nearby
where you can place the small pieces.
Note: There are two sizes of hex bolts. Make sure you’re
using the type specified in each step. Do not fully tighten
the bolts until you’ve completed the assembly and
checked to see if the alignment is correct.
Step 1
See Figure 1. Place leg connector (B) across and into
table leg (A).
Step 2
See Figure 2. Put the table base (C) above the leg and leg
connector (A and B) and match up the holes in the table
base (C) with those in the leg and leg connector (A and
B). Use the wrench (FF) to attach the table leg and leg
connector (A and B) to the table base (C) with 5 M8x70
bolts (AA), M8 washers (DD) and lock washers (CC).
AA
A
DD B
C
A
A
B
CC
Figure 2
Figure 1

your table is complete.
life is a play and you’ve just created center stage.
Step 3
See Figure 3. Use the wrench (FF) to attach the
assembled table base to the table top (D) with
4 M8x20 bolts (BB), M8 washers (DD) and lock
washers (CC).
Step 5
See Figure 4. Use the umbrella screw to tighten the
umbrella if necessary. If the table is used without an
umbrella, use the umbrella cap (E) to cover the
umbrella hole.
Step 4
Fully tighten all bolts and apply the bolt head caps
(EE) on to each bolt.
Figure 3
C
B
A
D
D
A
BB
CC
DD
Figure 4
B
E

blueoakoutdoor.com