modway EEI-1797 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 3
EEI -1797 OTTOMAN
Component:
1 Ottoman Seat Cushion x1 3 Leg x4
Thank you for purchasing the MODWAY OTTOMAN!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the ottoman, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 15 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
3
2
3
3
2 Ottoman Base x1
1
Hardware:
A Bolt x 8
D Allen Wrench x 1
B Spring Washer x 8
C Flat Washer x 8

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 3
EEI -1797 OTTOMAN
STEP 1:
STEP 2:
Please put the Ottoman Base (2) upside down on a carpeted or padded area by two adults to
make fully visible the corners.
Open the Zipper on the bottom of Ottoman (1) as shown, take out of the package of Legs (2) and Hardware Package.
Take out the 4pcs of Ottoman Legs (2) from the package, then close the Zipper on the bottom of Ottoman (1).
2
4pcs Leg
Zipper on the bottom
of ottoman body
+
Hardware Package
Position one of Ottoman Legs (B) at one of the four wooden corners.
Insert 2 pieces of Spring Washer (B), Flat Washer (C) into 2 pieces of Bolts (A) as shown.
Then insert assembled 2 pieces of Bolts (A) into the corner to connect the Leg (2).
Use Allen Wrench (D) to tighten the Bolts (A) clockwise until secure.
Repeat the same steps for the other three Legs (2).
Ax8 Bx8 Cx8 Dx1 Hardware & Tool required
2
3
3
3 3
A
A
A
D
A B
C
2
3

Customer Service 908-368-1025︱www.modwayfurniture.com Page 3 of 3
EEI-1797 OTTOMAN
Assembly is completed. The ottoman is ready to enjoy now!
STEP 3:
Carefully turn over the assembled ottoman.
Please take off the protection film on the Velcro of Ottoman Base (2).
Attach the Ottoman Seat Cushion (1) to the Ottoman Base (2) by the Velcro at the top of Ottoman Base (2) as shown.
Velcro
1
2
2
Protection film on the top of Velcro