BlueHive 035-7316-6 User manual

Wireless Charging Station with
Built-in Smart Watch Holder
User manual
This charging station allows you enjoy wireless charging easily. Please read
the user manual before using and keep it for future reference.
Specifications:
Input: DC 5 V 2 A
Wireless output: 5 V 1 A
USB output: 5 V 1 A
Frequency: 110–205 kHz
Charge efficiency: 65%
Charging distance: ≤8 mm
Model No. 035-7316-6

INSTRUCTIONS:
1. Place the Smart Watch onto the arm
2. Firmly press the charging cable into the route
3. Run the remaining cable through the slot
4. Firmly press the arm into the base
5. Plug the cable into the USB output.
Smart watch charger and cable:
Base
Arm
1
2
3
4
5

Connecting to power supply:
1. Connect USB 2.0 port to the power adaptor (or connect to laptop), and
micro USB port to the wireless charging dock.
2. The LED indicator will turn to green, entering into standby mode.
USB output
Micro USB Input Port

Note: if the phone case is metal, please remove before charging. Do not use
phone cases thicker 5 mm (3/16") for wireless charging.
Charging function:
1. Make sure the wireless charging dock is connected to a power supply,
and is in standby status.
2. Put the QI-enabled smart phone on the dock, LED indicator turns to blue
for charging. When the phone is fully charged, the LED indicator will turn
to green.
3. Attach the smart watch to the watch charger for charging.
LED Indicator
75% Cha rged
80% Cha rged

Warning:
1. Do not squeeze or drop the charging station.
2. Do not disassemble or throw into fire or water to avoid causing short
circuit leakage.
3. Do not use wireless charger in hot, humid or corrosive environments to
avoid damage.
4. Do not place wireless charger close to magnetic stripe or chip card (ID
card, bank card, etc.) to avoid magnetic failure.
5. Please keep the wireless charger at least 20 cm (7 7/8") from implantable
medical devices (heart pacemakers, implantable cochlea, etc.) to avoid
potential interference of the medical devices.
6. Please keep children away from the wireless charger to avoid unnecessary
accidents.
Made in China
Imported by Trileaf Distribution Toronto, Canada M4S 2B8
Product must be recycled or disposed of properly. Dispose of as per
the requirements of your local municipality
The ‘Qi ’ symbol is a trademark of the Wireless Power Consortium.
®