BM PRO RVMaster RVMC-LITE Reference guide

HELP GUIDE
PAIRING A
RVMC-LITE
RVMaster
POWERED BY

POWERING YOUR ADVENTURES
2
Due to a worldwide shortage on two microchips used in our products, BMPRO has
had to temporarily redesign the products you install.
The primary redesign is on the touch-screen RVMasterController installed in
RVMaster systems.
The redundancy keypad on the RVMasterController has been removed,
which means the way you pair RVMasterControllers, mobile devices, and
RVMasterSwitches has changed.
Unfortunately, because there are no redundancy buttons you will not be able to run
slide rooms, jacks or awnings or turn lights on or off quickly.
Internally, this updated RVMasterController is known as the RVMC-Lite.
Please remember this a temporary change. As soon as we can resume shipping
RVMCs with redundancy buttons, everything will go back to the way it was before in
terms of pairing RVMasterControllers and RVMasterSwitches. BMPRO appreciates
your patience as we navigate through these trying times.
We apologize for the temporary inconvenience. To pair an RVMC-Lite, please follow
the below instructions.
PAIRING TO THE RVMASTERNODE
1. Make sure the RVMasterNode’s firmware is
2.4.4 or higher by checking the box the Node
was shipped in, or by checking the green
sticker on the right side of the Node.
2. Launch the App on the RVMC-Lite.
3. Ensure the App is on the onboarding page.
4. Press and hold the BATHROOM switch for
at least 5 seconds, until a spinning circular
loading indicator appears in the center of the
screen. The pairing process will begin. This
could take up to 30 seconds.
NOTE: There is no immediate feedback when pressing the BATHROOM switch. If a
spinning circular loading indicator does not appear after 5 seconds, repeat this step.
Once pairing is successful, the app will take you to the Configuration menu. Configure
the RV for the correct floor plan. For additional support, refer to the RVMaster Owner’s
Manual.

POWERING YOUR ADVENTURES
3
DOC PART 036717
Rev.1.0
TEAM
BMPRO
.COM
BMPRO
821 E. Windsor Ave, Unit 1
Elkhart, IN 46514
[e-mail]
PAIRING RVMASTERSWITCHES
Due to the lack of time to implement an alternative method for pairing an
RVMasterSwitch, you will need to use a regular RVMC with working redundancy
buttons in order to pair a RVMasterSwitch.
Please hold back a regular RVMC and keep at the station where the
RVMasterSwitches are paired.
When pairing an RVMasterSwitch, you do not need to wait for the screen to boot.
You can use the redundancy buttons while the screen is off.
To pair a RVMasterSwitch to the RVMC-Lite:
1. Disconnect the CAN cable from the RVMC-Lite.
2. Connect the CAN cable to the RVMC with the redundancy buttons.
NOTE: Steps 3-6 are the same as before.
3. Using the lower keypad arrows, go to PA.
4. Press the RET button. PA will begin to flash.
7. Repeat steps 3-6 for remaining switches.
8. Disconnect the CAN cable from the RVMC with the redundancy buttons.
9. Connect the CAN cable to the RVMC-Lite.
5. Press two buttons at the same time on the RVMasterSwitch you want to pair. PA will
change to a number.
6. Press the EXT button to lock it in.