Air Lift Quick SHOT 25572 User manual

MN-516 • (102208) • ECR 10057
For maximum effectiveness and safety,
please read these instructions completely
before proceeding with installation.
Failure to read these instructions can result in an
incorrect installation.
INSTALLATION GUIDE
™
Kit 25572
Onboard Compressor
Control System
™


Introduction ................................... 2
Important Safety Notice .............................................2
Notation Explanation ................................................2
Installation Diagram ............................ 3
Installing the QuickShot System .................. 4
Recommended Compressor Locations ..................................4
Air Line Installation .................................................5
Limited Warranty and Return Policy ............... 8
TABLE OF CONTENTS

MN-516
2
Introduction
The purpose of this publication is to assist with the installation, maintenance and
troubleshooting of the QuickShot system.
It is important to read and understand the entire installation guide before beginning installation
or performing any maintenance, service or repair. The information here includes step-by-
step installation information.
Air Lift Company reserves the right to make changes and improvements to its products and
publications at any time. For the latest version of this manual, contact Air Lift Company at
(800) 248-0892 or visit our website at www.airliftcompany.com.
IMPORTANT SAFETY NOTICE
The installation of this kit does not alter the Gross Vehicle Weight Rating (GVWR) or payload
of the vehicle. Check your vehicle’s owner’s manual and do not exceed the maximum load
listed for your vehicle.
Gross Vehicle Weight Rating: The maximum allowable weight of the fully loaded vehicle
(including passengers and cargo). This number — along with other weight limits, as well
as tire, rim size and ination pressure data — is shown on the vehicle’s Safety Compliance
Certication Label.
Payload: The combined, maximum allowable weight of cargo and passengers that the truck
is designed to carry. Payload is GVWR minus the Base Curb Weight.
NOTATION EXPLANATION
Hazard notations appear in various locations in this publication. Information which is
highlighted by one of these notations must be observed to help minimize risk of personal
injury or possible improper installation which may render the vehicle unsafe. Notes are used
to help emphasize areas of procedural importance and provide helpful suggestions. The
following denitions explain the use of these notations as they appear throughout this guide.
INDICATES IMMEDIATE HAZARDS WHICH WILL RESULT IN SEVERE PERSONAL
INJURY OR DEATH.
INDICATES HAZARDS OR UNSAFE PRACTICES WHICH COULD RESULT IN SEVERE
PERSONAL INJURY OR DEATH.
INDICATES HAZARDS OR UNSAFE PRACTICES WHICH COULD RESULT IN DAMAGE
TO THE MACHINE OR MINOR PERSONAL INJURY.
Indicates a procedure, practice or hint which is important to highlight.
NOTE
DANGER
CAUTION
WARNING
QuickShot

MN-516 3
g. 1
Installation Diagram
1/4"
Air Line
Filter
Fuse Box
Fuse Adapter
Female Terminal
Fuse
Butt Connector
Butt Connector
Panel Assembly
(Figs. 3 & 4)
Pressure Switch
(110-145 PSI)
(Inset A)
Air Tank
(Fig. 6)
Tee Fitting
(Fig. 5)
Air Springs
(Previously Installed)
Air Springs
(Previously Installed)
Inflation Valve
Inflation Valve
Inflation Valve
(Fig. 7)
Supply Line (Red)
Tee Fitting
(Fig. 5)
Inflation Valve
Inflation Valve
AIR COMPRESSOR
(16190)
Ground
Auxiliary Hose
(Accessory Air Adapters
not included)
Inset AInset A
Adapter #1
Adapter #2
Adapter #3*
Adapter
Fuse
*Uses 3/16” (smaller) Female
Push On Connector
QuickShot
STOP! Missing or damaged parts? Call Air Lift customer
service at (800) 248-0892 for a replacement part.
Missing or damaged parts? Call Air Lift customer
service at (800) 248-0892 for a replacement part.

MN-516
4
Installing the QuickShot System
RECOMMENDED COMPRESSOR LOCATIONS
Important
LOCATE COMPRESSOR IN DRY, PROTECTED AREA ON VEHICLE.
DIRECT SPLASH OR EXCESSIVE MOISTURE CAN DAMAGE
THE COMPRESSOR AND CAUSE SYSTEM FAILURE.
Disclaimer: If you choose to mount the compressor outside the vehicle please keep in
mind the compressor body must be shielded from direct splash and the intake should be
snorkeled inside the vehicle. If the compressor does not include a remote mount air lter or
if mounting the compressor outside the vehicle, make sure to orient the compressor intake
lter so that all moisture can easily drain.
Please also remember...
• To avoid high heat environments
• To avoid mounting the compressor under the hood.
• To check to be sure the compressor harness #2 will reach the compressor and connect
to harness #1.
• The compressor can be mounted in any position — vertical, upside down, sideways,
etc. (please refer to the instruction manual).
Push-To-Connect Fitting
Leader Line
1/4" Air Line
Filter
Mounting Bolt
Flat Washer
Vehicle Body
Flat Washer
Star Washer
Nut
g. 2
g. 3
100
100
75
75
50
50
25
25
kg/cm
kg/cm
2
P.S.I.
P.S.I.
0
0
Inflate
Push Up
Deflate
Push Down
Inflate
Push Up
Deflate
Push Down
100100
7575
5050
2525
kg/cmkg/cm2
P.S.I.P.S.I.
00
Inflate
Push Up
Deflate
Push Down
Inflate
Push Up
Deflate
Push Down
100100
7575
5050
2525
kg/cmkg/cm2
P.S.I.P.S.I.
00
Inflate
Push Up
Deflate
Push Down
Inflate
Push Up
Deflate
Push Down
g. 4
To Tank
Air Lines to
Air Springs
Air Lines to
Air Springs
Air Lines to
Air Springs
To Tank Air Lines to
Air Springs
QuickShot

MN-516 5
Apply Thread Sealant to All Threaded Connection
s
Street Tee
Straight Fitting
Pressure Switch
Female Terminals
To the Fuse Box To the Compressor
Power Wire
To Air Springs
From the Compressor
Air Line
Air Line
g. 6
Air line to
air spring
Hex nut
Hex nut
Valve
Cap
Schrader
valve
Star washer
Rubber washer
Flat
washer
g. 7
AIR LINE INSTALLATION
Cut off excess air line squarely, using a sharp knife or air line cutter. Install the air
line into the self locking tting. Push and slightly turn the cut end of the air line into
the tting as far as it will go. A denite click can be heard and or felt when the air
line is seated. The air line should go in approximately 9/16” (14mm).
g. 5
QuickShot

MN-516
6
Notes
QuickShot

MN-516 7
Notes
QuickShot

MN-516
8
Air Lift Company reserves the right to make changes and improvements to its products
and publications at any time. For the latest version of this manual, contact Air Lift
Company at (800) 248-0892 or visit www.airliftcompany.com.
Replacement Part Information
If replacement parts are needed, contact Air Lift customer service. Most parts are
immediately available and can be shipped the same day.
Contact Air Lift Company customer service at (800) 248-0892 first if:
• Parts are missing from the kit.
• Need technical assistance on installation or operation.
• Broken or defective parts in the kit.
• Wrong parts in the kit.
• Have a warranty claim or question.
Contact the retailer where the kit was purchased:
• If it is necessary to return or exchange the kit for any reason.
• If there is a problem with shipping if shipped from the retailer.
• If there is a problem with the price.
Contact Information
Mailing address P.O. Box 80167
Lansing, MI 48908-0167
Shipping address 2727 Snow Road
for returns Lansing, MI 48917
Phone Toll free: (800) 248-0892
International: (517) 322-2144
Email service@airliftcompany.com
Web address www.airliftcompany.com
Air Lift Company provides a limited lifetime warranty to the original purchaser of
QuickShot™ from the date of original purchase, that the products will be free from
defects in workmanship and materials when used on cars and trucks as specified by Air
Lift Company and under normal operating conditions, subject to the requirements and
exclusions set forth in the full Limited Warranty and Return Policy that is available at:
www.airliftcompany.com/warranty.
For additional warranty information contact Air Lift Company customer service.
Limited Warranty and Return Policy
QuickShot


Need Help?
Contact Air Lift Company customer service
department by calling (800) 248-0892.
For calls from outside the USA or Canada,
dial (517) 322-2144.
Need Help?
Contact Air Lift Company customer service
department by calling (800) 248-0892.
For calls from outside the USA or Canada,
dial (517) 322-2144.
Air Lift Company • 2727 Snow Road • Lansing, MI 48917 or P.O. Box 80167 • Lansing, MI 48908-0167
Toll Free (800) 248-0892 • Local (517) 322-2144 • Fax (517) 322-0240 • www.airliftcompany.com
Thank you for purchasing Air Lift products — the professional installer’s choice!
Printed in the USA
JJC-0822
California: WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov
Table of contents