Bob's Card Models Gippsland Airvan GA8 User manual

1
Bob's Card Models
www.bobscardmodels.altervista.org and www.zealot.com [Resources]
Gippsland Airvan GA8
1:36

2
Technical Data
Engine : Lycoming I0-540-K1A5
Length : 8,9 m
Width : 12?4 m
Height : 3,9 m
Empty weight : 997 kg
Rate of climb : 242 m/minute (from sea-level)
Building Instructions
Print all sheets on 160g card, except Sheet 7 which is printed on 80-90g paper.
All green areas are to be cut out, but only when told to do so.
Fuselage
1. Assemble fuselage frame A- G, and glue 2 x 5g weights in the positions marked.
Glue Prop Shaft Tube [4] in position marked.
Fuselage frame
2. Cut out part [1] to oversize so that the Fold Arrows are included, round the folds with
a 5mm rod, then cut off the oversize. Fold/glue using the tabs, but leaving the front
portion open. Front portion: Cut the 2 green slits, then fold/glue also.
3. Close/glue the internal tab [2], then insert through [1], gluing in position.
4. Cut the 2 slits on [2], then glue [3] in position, first only ttogether he yellow part of the
tab, then when dry, close/glue [3]. The front portion of [3] is bent down, reinforced
with 2 pieces of waste card, holed with a cocktail stick, then glued in place.
5. Part [5] : Cut out part. Round/fold along fold lines (arrowed).. Cut out the 3 green
slits, insert and glue fin [7] in place, and close/glue front tab of [5]. Close/glue rear
wing [6] and insert through the relevant slits. Insert [7A] then by sandwiching

3
between the rear tabs of [5], then close/glue. Add part [7B]. Insert/glue the fuselage
frame in such a way that the prop shaft (a cocktail stick) inserted, marries with the
hole up front in the flap of [3. Join [5] to rear of [2] (if the rear part of the fuselage
frame is in the way, the rear portion – D and E can be cut off and discarded).
6. Paste Doors [9] over the doors of the plane.
Main Wing
7. Assemble parts [10L], [10R], spars and struts [11L], [11R] and [12].
8. Glue a [12] in place in each [11] as well as at their inner ends. Join/glue the two
spars together, so that they form an angle of 2x2.5°to each other (use the decal
provided).
9. Glue the 2 wings [10] in place.
10. Glue assembled wing in place: Cut out the green area on top of the cockpit, and a
small portion of the bulkheads, so that the wing fits snugly in place.
11. Glue the Inclined Spars (Fuselage to Wing) [14] in place.
Undercarriage
12. Roll/glue Undercarriage Spars [15]. Insert through relevant holes in Fuselage with
inside ends liberally glued. Glue exit from fuselage liberally.
13. Assemble and glue front wheel in place.
Varia
14. Add Cover flashing [13], which covers join between the 2 wing parts, as well as the
join fuselage-wing.
15. Glue the 2 exhausts [16] in position.
---oooOooo—

4