Boca Flasher LUMELINE User manual

Installation Manual
LUMELINE
WARNING: DO NOT LIFT FIXTURE BY CABLES.
This could result in permanent damage to both the xture and the cables. Damage resulting from grasping cables and/or putting
undue pressure on the cable connections will not be covered under the warranty! Do not attempt to install or use the LUMELINE
xture without reading the installation instructions and safety labels completely. Failure to adhere to these instructions could result in
serious injury or property damage. Do not modify, alter or attempt to service the LUMELINE. Doing so will void the warranty.

Installation Instructions
LUMELINE
Introduction:
The Boca LUMELINE is a line voltage xture that eliminates the need for secondary transformers, making installation contractor friendly.
The housing is anodized aluminum with a durable nish making it weather and abrasion resistant. It is UL Listed for dry, damp or wet location
(model dependent). See layout drawings for model provided.
Maintenance:
CLEANING Dry and Damp (IP65) Rated Fixtures: To clean surface use a soft damp cloth.
Wet (IP68) Rated Fixtures: To clean surface use a soft cloth with mild soap and water.
STORAGE Store in a dry, well-ventilated area when product is not in use.
Keep the electrical cord away from heated surfaces when in use or not in use.
If cord shows signs of damage do not use, return product to manufacturer.
Electrical Specifications:
1. Input Voltage: 90-120VAC
2. Total linear ft per 20A breaker: 200ft
3. Total linear ft per 15A breaker: 150ft
4. Input Current: Model dependent
Indoor | Outdoor Shallow Prole Line Voltage
Fixtures must be installed by a qualied and licensed
electrician in accordance with all national, state and
local electrical codes and regulations. If any part of
this manual does not meet the necessary codes and
regulations, contact the factory for more information
before attempting to install.
Model Dependent
Max temp: 55C
Min. temp: -40C
DAMP LISTING
IP65
WET LISTING
IP68
Turn Power Off At Circuit Breaker
Before Beginning Installation!
INCLUDED IN THIS PACKAGE:
Mounting Brackets
(2 brackets per xture)
Job Specic Drawings
12 3
Power cord length is
6.5 ft. per UL standard
LUMELINE
Swivel
Fixed
OR
3" Arc
OR
6" Arc
PAGE 2 OF 6
LUMELINE Fixtures
(In lengths shown on job specic drawings)

Installation Instructions
LUMELINE
PAGE 3 OF 6
1. INSTALL CLIPS INTO SUBSTRATE
Place the notch on the clip
into the rst notch of the
xture.
1a
Fixed Clips
1b
1a
Swivel Clips
1b
2a
3” Arc & 6” Arc Bracket Installation
Screw Information:
1. Screws not provided by Boca Flasher.
2. Boca Flasher recommends wide
washer at head Philips #8 screw
(not to exceed .418” in diameter).
3. Length of screw will vary depending
on mounting surface.
4. For outdoor installations, installer
should use a screw with
weatherproof coating.
1a 1b
2. INSTALL FIXTURE INTO CLIPS
snap!
▶
▶
Fixture will pivot
on notch as
it is pushed
down.
2b If using the Swivel Clip
or Arc Bracket loosen the
screw where the clip and
swivel bracket meet to ad-
just angle of the xture.
2d
Clip will securely
snap into place.
2c
Second Notch Detent
Angle
Screw
▶
▶
▶
▶
Install security screw using
supplied screw and driver.

3.1 CONNECT FIXTURES TOGETHER AS SHOWN ON JOBSPECIFIC DRAWINGS
Installation Instructions
LUMELINE
PAGE 4 OF 6
Labels on xtures correspond with
nomenclatures on drawings.
LUMELINE
▶
◀
▶
▶
BF-01
▶
▶
3.2 CONNECT FIXTURES TOGETHER TWISTLOCK CONNECTION
Connect Male and Female
twist lock cables in
order shown on job
specic drawings.
Push together and then twist until
completely connected and sealed
if outdoors.
3c
3b
See above for information
on determining layout.
3a
Rotate xture to
see bottom and
note each label.
3a Cross-reference with
job specic drawing.
3b 3cConnect Male and Female end caps in
order shown on job specic drawings.
Push together until it locks.
3d
IMPORtAnt nOtE:
Not screwing fixtures together represents an incomplete install and voids the
warranty. If any fixtures are damaged as a result of improper installation.
* For weather-tight applications only
See additional instructions for
weather-tight tape
* Add tape to twist locks.
Place thumb over tape at
starting point and
PULL around connector
area until tape overlaps
itself.

Installation Instructions
LUMELINE
PAGE 5 OF 6
4. CONNECT FIXTURES TO POWER
5. CONNECT TO A DIMMING SYSTEM
6. REMOVING FIXTURES FROM CLIPS IF NECESSARY
Slide a at head screwdriver in
between the clip and xture.
6a While holding the xture with your
other hand, pull back on screwdriver
to release from notch.
6b Once released from one notch,
xture can be fully removed.
6c
*NOTE: These xtures can dim on
forward (leading) or reverse (trailing)
phase dimmers. Boca Flasher does
not recommend the use of a“Smart”
or phase-adaptive dimming module.

Installation Instructions
LUMELINE
IMPORTANT SAFETY REMINDERS:
We are constantly improving our fixtures and reserve the right to change options and specifications. Additional information &
details at www.bocaflasher.com. For specific requirements, contact your Boca Flasher sales representative. Boca Flasher, Inc. 508
S. Military Trail, Deerfield Beach, Florida 33442 USA Phone: [phone] Fax: [phone] © 2017 Boca Flasher, Inc. All rights
reserved. All names and trademarks are property of their respective owners. REV 07-2017
DAMP LISTING
IP65
WET LISTING
IP68
1. DANGER:
To reduce the risk electric shock, always unplug the LUMELINE from electrical outlet before
cleaning. Cut breaker if outlet is not available.
2. To reduce the risk of burns, re, electric shock or injury to persons:
• UsetheLUMELINEonlyforitsintendeduseasdescribedintheseinstructions.
• DonotuseattachmentsnotrecommendedbyBocaFlasher.
• NeveroperatetheLUMELINEifithasadamagedcordorplug,ifitisnotworkingproperly,
if it has been dropped or damaged, or dropped into water. If the seal appears to be
damaged/broken/torn return the LUMELINE to a service center for examination or repair.
• Keepcordawayfromheatedsurfaces.
• Neverdroporinsertanyobjectintoanyopening.
• Donotoperatewhereaerosol(spray)productsarebeingusedorwhereoxygenis
being administered.
3. WARNING:
Do not attempt to install or use the LUMELINE without reading the installation instructions
and safety labels. Failure to adhere to these instructions could result in serious injury or
property damage.
4. Do not modify, alter or attempt to service the LUMELINE:
Doing so will void the warranty.
5. Do not use sharp tools near or on the xture lens:
Doing so will result in property damage and void the warranty.
Boca Flasher, Inc.
508 S. Military Trail nDeerfield Beach, Florida n33442 USA
Phone: [phone] nFax: 561-982-8323
www.bocaflasher.com