Bock Water heaters Electric Water Heaters User manual

Power Direct Vent
Gas Water Heaters
80 to 100 gallons/300,000 to 360,000 BTU
Co-axial vent
Sealed combustion
Low NOx construction available
Electronic ignition and controls
Non-CFC foam insulation
Automatic blower motor
Glass-lined storage tank
Hand hole cleanout
Sediment reduction system
Standard and ASME construction
NSF kit available
Complies with SCAQMD low NOx requirements
Design certified by CSA International (formerly AGA/CGA)
3-Year Limited Tank/1-Year Limited Parts Warranties
Energy Saver
80% Thermal Efficient

www.bockwaterheaters.com
110 South Dickinson Street , Madison, Wisconsin 53703
Toll Free 800.794.2491 • Phone [phone] ● Fax [phone]
80028 Rev 6/08
To order Natural Gas use the sux "NA", for LP use the sux "XA"; Example: 80PDV-300-NA
For ASME Construction add the sux "A" at the end; Example: 80PDV-300-NA-A
For LowNOx compliance to meet SCAQMD requirements, place an "LN" in the model number; Example:
80PDVLN-300-NA
T=Top, F=Front, R=Rear
These models meet or exceed theThermal Eciency and Standby Loss Requirements of ASHRAE 90.1b current standard.
115V A.C. Required
T&P Valve, Brass Drain Valve, Diaelectric Fittings, Magnesium Anode Rods: Factory Installed
Pressures (all): Working Pressure, 150 psi; Tested Pressure, 300 psi
Warning: Installation should be in accordance with all national and/or local codes. In the absence of local codes, refer to NFPA 54 or ANSI Z21.10.1.
Caution: The recommended maximum hot water termperature setting for normal residential use is 120°F. Bock recommends a tempering valve or anti-scald
valve be installed and used according to the manufacturer’s directions to prevent scalding.
Energy Saver
Power Direct Vent
Gas Water Heaters
This product is available from:
MODEL
NUMBER
STORAGE
(GAL)
RATED
INPUT
(BTU/HR)
1ST HR
DEL GAL
@ 100°F
RISE
RECOVERY GPH
@ DEGREE RISE
DIMENSIONS (INCHES) SHIPPING WEIGHT
A
HEIGHT
B
DIA.
C
TOP
WATER
CONN.
D
FRONT
HOT
CONN.
E
FRONT
COLD
CONN.
F
GAS
CONN.
G
TOP
VENT
HEIGHT
WATER
CONN.
GAS
CONN.
DIA.
RELIEF
VALVE
OPEN.
STD
(LBS)
ASME
(LBS)40°F 100° F 140° F
80PDV-300 80 300,000 347 728 291 208 63-7/8 28-1/4 65-3/4 51-1/2 20-3/4 14 69-1/2 1-1/2 (T&F)
2 (R) 3/4 1 665 740
100-PDV-360 100 360,000 419 873 349 249 72-7/8 28-1/4 74-3/4 60-1/2 20-3/4 14 74-1/2 1-1/2 (T&F)
2 (R) 3/4 1 735 815
(LN) LowNOx Burners RECOVERY GPH @
DEGREE RISE
40° F 100° F 140° F
80PDVLN-300 280,000 BTUH 679 272 194
100PDVLN-360 335,200 BTUH 812 325 232
B
1 1/2” FRONT OUTLET
2” REAR OUTLET
E
F
3/4” GAS
CONNECTION 1 1/2” FRONT INLET
2” REAR INTLET
44 5/8
D
C
A
G
21”